Modern Dual Monitor & Laptop Stand with Adjustable Width

Components

• A Cam Connector (x8)
• B Cam Screw (x8)
• C Pin (x2)
• D (x2) - Small part for slots
• E Allen Key Screwdriver
• F Short Panel (x2)
• G Long Panel (x2)
• H Platform (x2) (Left x1, Right x1)
• I Centre Platform

Assembly Instructions

1. Attach Cam Screws to Centre Platform

   Attach four (x4) Cam Screws (B) to the Centre Platform (I). Tighten using the Allen Key Screwdriver (E). Ensure the Cam Screws (B) are properly inserted so the body of the screw sits flush with the panel's surface.

   Diagram: Shows Cam Screws (B) being inserted into Centre Platform (I).

2. Attach Short Panels

   Attach the Short Panels (F) to the Centre Panel (I) by aligning the Cam Screw (B) with the holes in the side of the Short Panel (F).

3. Insert Cam Connectors

   Insert four (x4) Cam Connectors (A) into the holes in the Short Panels (F), ensuring the arrow on the Cam Connector (A) is pointing towards the head of the Cam Screw (B).

4. Lock Panels Together

   Lock the panels together by rotating the Cam Connectors (A) in a clockwise direction (?) using the Allen Key Screwdriver (E). Note: Ensure correct insertion of Cam Screw (B) and Cam Connector (A) with the arrow pointing towards the screw head; incorrect examples are marked with '❌'.

5. Insert Pins

   Flip the assembly over and insert two (x2) Pins (C) into the holes on the top surface.

   Diagram: Shows Pins (C) being inserted into the top surface.

6. Attach Cam Screws to Outer Platforms

   Attach four (x4) Cam Screws (B) to the Left & Right Platforms (H). Tighten using the Allen Key Screwdriver (E). Ensure the Cam Screws (B) are properly inserted so the body of the screw sits flush with the panel's surface.

7. Attach Long Panels

   Attach the Long Panels (G) to the Centre Panel (I) by aligning the Cam Screw (B) with the holes in the side of the Short Panel (F).

8. Insert Cam Connectors into Long Panels

   Insert four (x4) Cam Connectors (A) into the holes in the Long Panels (G), ensuring the arrow on the Cam Connector (A) is pointing towards the head of the Cam Screw (B).

9. Lock Long Panels

   Lock the panels together by rotating the Cam Connectors (A) in a clockwise direction (?) using the Allen Key Screwdriver (E).

   Diagram: Similar to step 4, showing locking mechanism.

10. Attach Outer Platform Assemblies

    Attach the two (x2) outer platform assemblies to the centre assembly, ensuring the Pins (C) are aligned with the slots on the underside of the outer platforms.

    Diagram: Shows outer platform assemblies being connected via Pins (C).

11. Insert Part D

    Insert two (x2) Part (D) into the slots on the top surface of the outer platforms.

    Diagram: Shows Part (D) being inserted into slots.

12. Adjust Width and Angle

    Adjust the width and angle of the stand to your requirements by sliding the outer platforms to the desired position.

    Diagram: Shows the two outer platforms being slid into position to adjust width and angle.

WARNING: The weight capacity of each side of the stand is 10kg. Do not exceed the weight capacity.

Notes

This section is for user notes.

Need More Information?

We hope this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.Kogan.com.