Paul Neuhaus 833604 Q-VITO Smart Home LED Pendant Light
Installation and Operation Manual
Product Information
Brand: Paul Neuhaus
Model: 833604
Product Type: Smart Home LED Pendant Light
Energy Efficiency: This product contains a light source of energy efficiency class <F>. (Other languages available).
Technical Specifications
| Specification | Details |
|---|---|
| Voltage | 230V / 50Hz |
| Light Source | 1x LED-Board (55V DC / 58W) - not changeable |
| Wireless Frequency | 2.4 GHz |
| Max Transmit Power | 10 dBm |
| Power Consumption | 58W |
| Luminous Flux | 7,000 lm |
| LED Board Lifespan | 20,000 hours |
| Color Temperature | 2,700 - 5,000 K |
| Switching Cycles | 15,000 |
| Switch-on time | <0.5 seconds |
Included Accessories
- 1x IR Remote Control
- 2x AAA Batteries
Fitting Instructions
Follow these steps to correctly fit the pendant light:
- Prepare the ceiling for mounting. This may involve drilling a hole of approximately Ø8mm.
- Secure the mounting bracket to the ceiling using appropriate hardware.
- Attach the light fixture to the mounting bracket.
Diagram Description: The diagram shows the light fixture being attached to a ceiling bracket with screws. It indicates the use of mounting hardware and the required hole diameter.
Electrical Connection
Connect the light to the mains power supply (230V / 50Hz) as follows:
- Identify the Live (L) and Neutral (N) wires from your mains supply.
- Connect the Live wire to the 'L' terminal on the light fixture.
- Connect the Neutral wire to the 'N' terminal on the light fixture.
Diagram Description: The diagram illustrates the electrical connection, showing the mains power input terminals labeled 'L' and 'N' on the light fixture, and how the corresponding wires from the power source should be connected.
Remote Control Setup and ZigBee Integration
Pairing the IR Remote Control
To pair the included IR remote control with the light fixture, perform the following sequence:
- Switch the light on.
- Turn the light off and on again 5 times.
- Ensure the first on/off cycle is between 5-10 seconds.
- Subsequent on/off cycles should be between 1-2 seconds each.
- The light will indicate successful pairing.
Diagram Description: The diagram shows a sequence of power cycles (on/off) with specific time intervals (5-10 sec, 1-2 sec) to pair the remote control. It also shows the remote control and the light fixture.
Resetting for ZigBee Network Integration
To integrate the lamp into a ZigBee network, reset the lamp to its factory settings:
- Switch the lamp on.
- Turn the lamp off and on again 5 times, with 1-2 second intervals between each cycle.
The light will indicate a successful reset.
Diagram Description: The diagram illustrates the reset process by showing the light being switched on and off multiple times (5 times) with short intervals (1-2 seconds) between each action.
For detailed operation of the remote control, please refer to the separate "Q-remote control manual".
