Endorfy Arx 500 Air PC Case Installation Guide

Accessories

The following accessories are included:

• Accessory A: Screws for mounting the motherboard (x13) [screw]
• Accessory B: Screws for mounting 2.5" SSDs (x22) [screw]
• Accessory C: Screws for mounting the PSU (x6) [screw]
• Accessory D: General case screws (x20) [screw]
• Accessory E: Cable management zip ties (x6) [zip tie]
• Accessory F: Screws for fans (x1) [screw]
• Accessory G: PWM fan splitter (x1), allowing multiple fans to connect to one motherboard header.
• Also included are Endorfy Stratus 140 PWM fans.

Overview of Case Features

The Arx 500 Air PC case supports various component configurations:

• Rear: Supports 1x 120/140mm fan or 1x 120mm radiator.
• Top: Supports 1x 120/140mm fan or 1x 120/240/280mm radiator.
• Front: Supports 2x 120mm fans or 2x 140mm fans, and 1x 120/240/280/360mm radiator. Features a mesh front panel for airflow.
• Bottom: Houses the PSU, with a maximum length of 300mm, and includes a PSU filter.

Front Panel I/O Connections

The front panel provides the following connections:

• Power button
• Power LED
• HDD LED
• Reset button
• USB port
• Microphone port
• Headphones port
• USB port
• USB-C port

Installation Steps

1. Panel Removal

The side panels of the case can be removed to access the interior.

2. PSU Installation

Install the Power Supply Unit (PSU) into the designated compartment at the bottom of the case. Ensure the PSU length does not exceed 300mm.

3. Motherboard Installation

Mount the motherboard onto the case standoffs using the provided motherboard screws (A). Connect the front panel I/O cables (Power button, LEDs, Reset, USB ports) to the corresponding headers on the motherboard, referring to your motherboard manual for correct placement.

4. Component Installation (SSDs and HDDs)

Install 2.5" SSDs and 2.5"/3.5" HDDs into their respective mounting points using the appropriate screws (B, C, D, F). The case includes specific locations for multiple SSDs and HDDs.

5. Dust Filter Installation

Slide the dust filter into its designated slot, typically located at the bottom of the case, to help keep internal components clean.

6. Fan Connection

Connect the included PWM 4-pin fans to the provided PWM splitter. The splitter can then be connected to a single motherboard fan header (e.g., CHA_FAN) to manage fan speeds.

Safety Instructions

Please adhere to the following safety guidelines:

• Use the product as intended. Incorrect use may cause damage or health risks.
• Ensure the product is in good working order before use.
• The warranty does not cover mechanical damage.
• This device is for indoor use only, under normal humidity conditions. Do not use outdoors.
• Keep the device away from children.
• Allow the device to reach ambient temperature before connecting to prevent condensation damage.
• Clean only with a dry, clean cloth. Do not handle with wet hands.
• The device contains no user-serviceable parts; contact authorized service for repairs.
• Do not use near or expose the product to liquids. Disconnect from power immediately if contact occurs.
• In case of malfunction, disconnect power immediately and contact ENDORFY Technical Support.
• Do not dispose of electrical and electronic equipment with household waste.
• End-users are responsible for proper disposal of electrical equipment at designated collection points or by returning to the seller.

Product Disposal: The symbol ♻️ indicates that this product and its battery (if included) should not be disposed of with household waste. It must be taken to a special collection point designated by local authorities. Separate collection and recycling help conserve natural resources and ensure safe processing for health and the environment.