Assembly Instructions

Before Assembly

READ & SAVE BELOW INSTRUCTIONS BEFORE ASSEMBLY

1. Please separate and identify all parts, making sure that you have all of the parts listed.
2. To avoid any scratch during assembly, please assemble on a soft mat or similar.
3. Please assemble step by step and follow the instructions.
4. Washers must be used.
5. While each screw and nut is properly fastened, do not over fasten it.
6. Do not completely fasten each screw and nut until all the screws are properly fixed.

Important Notes:

Install all the relevant screws, but do not tighten them completely at the very beginning. Tighten the screws fully one by one.

Don't tighten up the screw before you start next mounting during the installation. [!]

Assembly Steps

Step 1

Connect part A and part B using screws K, nuts L, and tool M. Ensure the connections are snug but not fully tightened.

Step 2

Attach part C to the assembled section using screws N and tool M. Again, do not fully tighten yet.

Step 3

Continue attaching parts D to the main structure using screws N and tool M. Maintain loose fittings for now.

Step 4

Attach the legs (parts E and F) to the base of the chair using screws H and washers S. Use tool N for tightening.

Step 5

Place the seat cushion (part G) into the chair frame. Ensure it fits snugly.

Final Tightening

Once all parts are assembled, go back and fully tighten all screws and nuts using the provided tools.