Maxpeedingrods Suspension Kit Installation Guide

Removing the Bump Stop

Step 1: Raise the vehicle with a jack and let the suspension kit assembly be put into position between the axle and frame.

Step 2: Remove the factory bump stop.

Diagram Description: A visual representation showing the vehicle frame and axle, with the factory bump stop positioned for removal.

Installing the Upper and Lower Brackets

Step 1: Attach the upper mounting bracket (3) of the Rubber kit list) to the frame.

Diagram Description: An illustration showing the upper mounting bracket being attached to the vehicle's frame.

Step 2: Install the rubber spring (1) of the Rubber kit list) to the upper mounting bracket (3) of the Rubber kit list) with washers and lock nuts.

Diagram Description: A diagram illustrating the rubber spring being fitted onto the upper mounting bracket, secured with washers and lock nuts.

NOTE: If necessary, you can use spacers to achieve the desired height.

Finalizing Installation

Step 3: Install the lower mounting bracket (10) of the Rubber kit list) with block (14 of the Rubber kit list) to the axle.

Diagram Description: A depiction of the lower mounting bracket and block being attached to the vehicle's axle.

Step 4: Repeat the same process on the other side.

Installation Completed

WARNING:

Cancer and Reproductive Harm

For more information, visit www.P65Warnings.ca.gov.