1:32 RC Vehicle - Model F36835-0000-ISH-4L01A

Important Information

Please retain this instruction sheet as it contains important information.

Note to Adults: To ensure safe and enjoyable play, please review all operating instructions and safety tips in the CONSUMER INFORMATION section with your child.

Consumer Information

Contents:

• 1 x Vehicle
• 1 x Transmitter Controller

Safety Tips:

• Do not operate the vehicle near or in water, snow, sand, grass, or any wet or muddy surfaces, as the electronics can get wet, causing the toy's surface to become hot and potentially cause burns.
• Never play with this vehicle on streets; streets are for real cars.
• Do not pick up the vehicle while it is in motion.
• Always place the car gently on the floor by hand. Never throw the car onto the floor.
• Avoid collisions with walls, hard objects, or people/animals.
• Keep fingers, hair, and loose clothing away from tires and wheel hubs.
• Remove all batteries from the controller when not in use to avoid accidental operation.
• Do not connect this toy with other power supplies or insert any wire into electrical outlets.
• Rest the vehicle for at least 5 minutes after every 15 minutes of operation.
• Stay clear of obstructions and hazards to avoid injury and damage.

Battery Installation

Vehicle Battery Requirements:

This vehicle requires 2 (two) standard “AAA” batteries.

Controller Battery Requirements:

The transmitter controller requires 2 (two) standard “AAA” batteries.

Installing Batteries in the Vehicle (See Diagram 1):

1. Push the ON/OFF switch on the underside of the vehicle to the “OFF” position.
2. Using a screwdriver (not included), remove the battery compartment door.
3. Remove and properly dispose of used batteries (if any).
4. Insert 2 “AAA” batteries, observing the polarity (+/-) as shown inside the battery compartment.
5. Replace the battery compartment door.

Diagram 1: Shows the battery compartment on the underside of the vehicle and the correct orientation for inserting two AAA batteries.

Installing Batteries into Controller (See Diagram 2):

1. Press the lock button down with a screwdriver and slide the door open.
2. Remove and properly dispose of used batteries (if any).
3. Insert 2 “AAA” batteries, observing the polarity (+/-) as shown inside the battery compartment.
4. Replace the battery compartment door.

Diagram 2: Illustrates opening the controller's battery compartment, removing old batteries, and inserting two AAA batteries with correct polarity.

Battery Safety Information

• It is recommended to use only Alkaline type batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Remove batteries if the vehicle will not be used for a long period to prevent possible battery leakage.
• Dispose of batteries safely. Do not dispose of batteries (or products containing non-replaceable batteries) in fire, as batteries may explode or leak.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are to be charged by an adult only.
• Non-rechargeable batteries are not to be recharged.
• Do not mix different types of batteries or new and used batteries.
• Insert batteries with the correct polarity.
• Remove exhausted batteries from the toy promptly.
• The supply terminals are not to be short-circuited.

Quick Tips

• When your vehicle starts to lose power, it may lose function or performance; replace batteries with fresh ones. Running time depends on driving style.
• Radio interference can cause abnormal operation. Interference may be caused by other R/C vehicles on the same frequency, electrical wires, large buildings, or CB radios. Try to stay away from these sources.
• Do not store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries for storage.
• If the vehicle resets automatically, the batteries are weak and need to be changed.
• Performs best on a flat, smooth floor or surface.

Cleaning Instruction

• To clean, wipe excess dirt from the toy. Remove batteries first.
• Wipe the toy clean with a damp cloth and then wipe dry.
• DO NOT IMMERSE IN WATER and DO NOT CLEAN VEHICLE WITH ANY CHEMICALS.
• Let the toy completely dry before putting batteries back into the clean, dry battery compartment.

Instruction for Disposal of Waste

• Batteries and electronic toys should be recycled or disposed of per your local waste management guidelines.
• Contact your local waste management officials for information regarding environmentally sound recycling and disposal of batteries and electronic toys.
• Electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
• Products with batteries should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

How to Play

1. Turn the vehicle ON, then press any button on the transmitter controller within 15 seconds for pairing.
2. The LED on the controller will blink for pairing.
3. Once pairing is successful, the LED on the controller will stop blinking and stay on.
4. If pairing is unsuccessful, turn the vehicle OFF and reinstall the battery in the controller to try again.

• If your controller LED is blinking or losing brightness, please replace the battery.
• When playing with multiple vehicles, pair only one controller to one vehicle at a time to avoid interference.

Troubleshooting

Vehicle Will Not START

• Problem: Power switch is OFF. Solution: Turn the power switch ON.
• Problem: Batteries are installed with incorrect polarities. Solution: Check the + and - markings to ensure batteries are properly aligned.
• Problem: Batteries are drained. Solution: Replace batteries and/or install new batteries.

Vehicle Does Not Respond to Controls / Vehicle Does Not Move / Vehicle Does Not Respond Properly

• Problem: Stop operation, switch off the power, and rest the vehicle for a few minutes.
• Problem: Batteries in the vehicle may have been knocked loose during play. Solution: Check the position of the batteries in the vehicle.
• Problem: Vehicle is out of range. Solution: Bring the controller closer to the vehicle.
• Problem: Batteries are drained. Solution: Replace batteries and/or install new batteries.
• Problem: Interference from surrounding electrical machinery. Solution: Play with your vehicle in a wide open space.

Transmitter Controller Does Not Work

• Problem: Controller light is off, its battery is drained. Solution: Replace the controller battery.

Vehicle Does Not Convert

• Problem: Batteries are drained. Solution: Replace batteries and/or install new batteries.

Warranty Information (30-Day Limited Warranty)

Jada Toys, Inc. warrants to the original consumer purchaser that this product will be free of defects in material and workmanship for thirty (30) days from the date of purchase. Jada Toys will repair or replace the product, at its sole discretion, in the event of such a defect within the warranty period.

For customer support, please contact Jada Toys:

• Phone: 1-800-679-5232 (Monday – Friday, 8:30 am to 5:30 pm Pacific Time)
• Email: cs@jadatoys.com

Include your name, address, telephone number, a copy of your dated sales receipt, and a brief explanation of the defect. Repair/replacement and return shipment will be free of charge.

This warranty does not cover damage resulting from unauthorized modification, accident, misuse, or abuse. This warranty gives you specific legal rights, and you may have other rights which may vary from state to state.

Regulatory Information

FCC Warning:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment causes harmful interference to radio or television reception, try to correct the interference by reorienting or relocating the receiving antenna, increasing the separation between the equipment and receiver, connecting the equipment to an outlet on a different circuit, or consulting the dealer or an experienced radio/TV technician.

Industry Canada Warning:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. The device can be used in portable exposure condition without restriction.

Product Specifications & Compliance

• RF frequency band: 2418-2462 MHz
• Transmitter power: -9.37dBm
• JADA TOYS CO. LTD. declares that the radio equipment type #36835 is in compliance with Directive 2014/53/EU.
• The product uses 2.4GHz remote control technology.
• Made in Vietnam.

Jada oval mark is a registered trademark of Jada Toys, Inc. We reserve the right to improve or amend product specifications. Colors may vary.