IKEA LAGAN Integrated Dishwasher Installation Manual
Brand: IKEA
Important Safety Information
[warning] Before proceeding with installation, read the safety information in the User Manual.
This document provides installation instructions. Ensure all safety precautions are followed.
Tools Required
- [measuring tape]
- [screwdriver]
- [spirit level]
- [scissors]
- [drill]
- [gloves]
- [tape]
Parts Included
| Part | Description | Quantity |
|---|---|---|
| A | Screw | 18x |
| B | Spring | 2x |
| C | Clip | 1x |
| D | Bracket | 2x |
| E | Bracket | 1x |
| F | Bracket | 1x |
| G | Rail | 1x |
| H | Cam Lock / Knob | 2x |
| I | Screw | 2x |
| J | User Manual | 1x |
Installation Space and Dimensions
The appliance requires a cabinet space with the following approximate dimensions:
- Height: 840 mm to 880 mm
- Width: 550 mm
- Depth: 450 mm
Appliance dimensions:
- Height: 835 mm to 875 mm
- Width: 448 mm
- Clearance: 120 mm at the front bottom, 45 mm at the rear bottom.
[warning] Ensure proper clearance and connections for water supply and drainage.
Assembly Steps
Step 1
Attach rail G (1x) to the appliance using the provided fixings.
Step 2
Secure components using screws (I, 2x) and cam locks (H, 2x).
Step 3
Attach clip C (1x) to a 450 mm long cabinet panel.
Step 4
Carefully slide the appliance into the installed cabinet space.
Step 5
Secure the appliance using the provided brackets and screws.
Step 6
Attach components to a panel. Use tape (4x) for securing. Note weight limits: 3.5 kg to 8.5 kg. Refer to user manual J (1x).
Step 7
Attach brackets D (2x) and screws A (4x). Drill pilot holes with a Ø2 drill bit, maximum depth 10 mm.
Step 8
Attach brackets D (1x), E (1x), and F (1x) using screws A (4x each). Drill holes with a Ø10 drill bit, ensuring 5 units spacing between holes.
Step 9
Adjust the appliance door hinges for proper alignment and closure.
Step 10
Secure the appliance to the cabinet using screws A (2x) and springs B (2x).
Water Connection
[warning] Ensure correct water supply and drainage connections.
Connect the water inlet hose to the tap and the water outlet hose to the drain.
Correct Connections:
- Water inlet hose connected to tap.
- Water outlet hose connected to drain pipe.
Incorrect Connections:
- [not allowed] Direct connection of inlet hose to tap without proper fitting.
- [not allowed] Improper drainage connection leading to leaks.
Maximum hose length for water connections is 1000 mm (100 cm).
Ensure water hoses are routed correctly, avoiding kinks or damage.
