Fiamma Carry-Bike Fixing Bar Kit

Package Contents

The package contains the following items:

• Part A: 2x
• Part B: 2x
• Part C: 10x
• Part D: 10x
• Part E: 1x
• Part F: 1x
• Part G: 12x
• Part H: 12x
• Part I: 4x
• Part L: 12x

Required tools (not included): Screwdriver, wrench, drill (with 5 mm bit), sealant (e.g., SIKA 252).

Dimensions and Weight

Dimensions:

• Length: 242 cm
• Width: 2 cm
• Height: 4 cm

Weight: 5.5 kg

Pre-Installation Checks

Before installation, please perform the following checks:

• Ensure all parts are undamaged and not deformed from transport.
• If you have any doubts or questions regarding the installation, use, or limitations of the product, please contact your dealer.

Installation Instructions

Follow these steps carefully for correct installation:

Step 1: Initial Bar Attachment

Attach the main bar to the vehicle panel. Use screws (Part A, Part B) and sealant (e.g., SIKA 252) for secure mounting. A 5 mm drill bit is required for pilot holes.

Visual Description: Diagram shows a vehicle panel with two horizontal slots. A long bar is positioned above these slots. Screws (A, B) are shown being inserted through holes in the bar and into the panel. A tube labeled SIKA 252 indicates adhesive application. Parts C and D are shown nearby, likely for alignment or reinforcement.

Step 2: Adding Components

Attach additional bar components using parts L, A, H, and G. Arrows in the diagram indicate the direction of assembly.

Visual Description: Diagram shows a section of the bar with parts L and A being attached. Nuts (H) and washers (G) are shown being used with screws. Arrows indicate the sliding or fastening direction.

Step 3: Further Assembly

Continue assembly by attaching parts E, I, H, G, and F to the main bar structure.

Visual Description: Diagram shows the bar assembly with parts E and F being attached to the ends or sides. Parts I, H, and G are used for fastening and reinforcement.

Step 4: Final Assembly

The final configuration of the reinforcement bar assembly is shown.

Visual Description: Diagram shows the fully assembled reinforcement bar, ready for mounting to the vehicle.

Important Warnings and Responsibilities

Fiamma declines all responsibility for personal injury or damage to property resulting from incorrect assembly or use of this product. It is recommended to keep these instructions inside the vehicle.

• The product must be assembled strictly according to the provided instructions. Do not modify the product in any way.
• Always comply with speed limits and traffic regulations. The speed must be appropriate for traffic conditions and the transported load.
• Periodically check that the product is securely attached. Pay special attention after the first few kilometers of driving post-installation and before and after any long journeys.

Warranty Information

In case of defects related to materials and manufacturing, customers are entitled to warranty coverage in accordance with the local laws and regulations of the country where the product was purchased.

(Note: Icons representing waste disposal and recycling are present on page 7, indicating environmental considerations.)

Manufacturer Information

Fiamma S.p.A.

Via San Rocco, 56

21010 Cardano al Campo (VA)

Italy

Website: www.fiamma.com

Fiamma S.p.A. reserves the right to modify at any time, without notice, prices, materials, specifications, and models, or to cease production of any model. All rights reserved.