MITTLED LED Lighting Strip
Important Safety Instructions
For indoor use only. Regularly check the cord, the transformer, and all other parts for damage. If any part is damaged, the product should not be used. Keep these instructions for future use.
The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
Important: ONLY USE A SAFETY TRANSFORMER WITH A SELV OUTPUT AS A SUPPLY FOR THE PRODUCT.
Use only IKEA LED drivers suited for this product. The total wattage of the lamps connected to one LED driver must not exceed the maximum power stated on that LED driver and never more than 30W.
Warning: Risk of strangulation hazard. NEVER place cord within reach of a child in a cot or playpen. ALWAYS secure cord to wall or cabinet. Check regularly that the cord is securely fastened. Pull the cord to remove any slack between fasteners. Tie up any remaining slack cord between driver and socket.
Assembly Instructions
Components Included: The package typically contains mounting brackets, screws, the LED light strip, an LED driver, and a power cord (note: LED driver and power supply cord may be sold separately).
Step 1: Prepare Mounting Brackets Cut the provided metal strip according to the indicated lines. Bend the metal strip to form a bracket, ensuring it has the correct holes for mounting.
Step 2: Mount Brackets Using a screwdriver, attach two prepared brackets to the underside of the cabinet or shelf with screws. Ensure they are securely fastened.
Step 3: Attach Light Strip Align the LED light strip with the mounted brackets. Push the strip into place until it clicks securely.
Step 4: Connect Multiple Light Strips (If applicable) To connect additional light strips, slide the connector from one strip into the corresponding connector on the next strip until it clicks.
Step 5: Secure Connections Ensure all connected light strips are firmly attached to their respective brackets and that all connections are secure.
Step 6: Final Check Verify all connections are stable and the light strip is properly installed.
Maximum Units: A maximum of 10 units can be connected together.
