MITTLED LED Kitchen Lighting Strip

Important Safety Instructions

For indoor use only.

Regularly check the cord, the transformer, and all other parts for damage. If any part is damaged, the product should not be used.

Important information! Keep these instructions for future use.

The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.

ONLY USE A SAFETY TRANSFORMER WITH A SELV OUTPUT AS A SUPPLY FOR THE PRODUCT.

Use only IKEA LED drivers suited for this product. The total wattage of the lamps connected to one LED driver must not exceed the maximum power stated on that LED driver and never more than 30W.

WARNING – Strangulation hazard. NEVER place cord within reach of a child in a cot or playpen. ALWAYS secure cord to wall or cabinet. Check regularly that the cord is securely fastened. Pull the cord to remove any slack between fasteners. Tie up any remaining slack cord between driver and socket.

Assembly Instructions

Tools Required: Screwdrivers and scissors.

Components: The product includes the LED light strip, an LED driver, a power supply cord, mounting brackets, and screws. The LED driver and power supply cord are sold separately.

Step 1: Prepare Mounting Brackets

Take the metal mounting brackets. Using scissors, cut along the indicated line on the bracket. Then, bend the bracket to the correct shape as shown in the diagram.

Step 2: Attach Brackets to Surface

Position the prepared mounting brackets on the underside of your cabinet or shelf. Secure each bracket using the provided screws. Ensure they are firmly attached.

Step 3: Install Light Strip

Align the LED light strip with the mounted brackets. Slide the strip into the brackets until you hear a 'click', indicating it is securely in place.

Step 4: Connect Components

Connect the power supply cord to the LED driver. Then, connect the LED driver to the LED light strip. Ensure all connections are secure.

Step 5: Connect Additional Strips (if applicable)

If installing multiple light strips, connect them sequentially to the LED driver, following the same procedure as Step 4 for each connection. Ensure the total wattage does not exceed the driver's capacity or 30W.

Step 6: Final Check

Ensure all connections are secure and the light strip is properly mounted. The system supports a maximum of 10 units.