U PROX U-PROX SE KEYPAD Universal Reader With OSDP and Keypad
Specifikationer:
- Produkt: U-PROX SE KEYPAD
- Funktioner: Universal reader with OSDP and keypad
- Grænseflader: OSDP, Wiegand 26, 32, 34, 37, 40, 42, 56, 58, 64,80 bits, RS232, TouchMemory
- Understøtter: Mifare DESFire EV1, EV2, EV3 cards
- Kryptering: AES encryption algorithm
- Garanti: Two years (except batteries)
Produktbrugsvejledning
Installation:
- Make a small recess or hole (diameter is 14 mm) to connect the cable under the reader’s case.
- Løsn skruen i bunden af læseren.
- Fjern topdækslet.
- Carry out wiring to the control panel.
- Mount the reader on the wall using supplied plastic dowels and screws.
- Place the top cover and tighten it with a screw.
Note: Avoid installing on metal surfaces to prevent a decrease in reading range. Maintain a minimum distance of 20 cm between readers unless interconnected with yellow wires for synchronized operation.
Forbindelse:
Use multi-core signal cable with 0.22 mm² cross-section of each wire between reader and panel for seamless connection. Various interfaces like OSDP, Wiegand, RS232, and TouchMemory are supported.
Konfiguration:
Utilize the U-Prox Config mobile application for adjusting reader settings, including indication and encryption modes. To set the engineering password, connect inputs D0 (green) and D1 (white) and apply power to the reader. Firmware updates can be done with an NFC-enabled Android smartphone.
Mobil identifikation:
The U-PROX ID application facilitates receiving, storing, and transmitting mobile credentials between the reader and smartphone.
Mobile IDs can be purchased from authorized dealers.
RFID, 125 kHz:
While these cards lack cloning protection, they are cost-effective. For enhanced security, it is recommended to encrypt all card sectors with a diversified encryption key. The reader supports Mifare DESFire EV1, EV2, and EV3 cards with AES encryption.
Beskrivelse
U-PROX SE keypad – the adjustable universal SmartLine reader with a wireless keypad for mobilecredentials and proximity identifiers.
In conjunction with the U-PROX ID application and mobile identifiers U-PROX IDs allow any accesscontrol system to use smartphones as access system credentials.
Installation
- Lav en lille fordybning eller hul (diameter er 14 mm) for at forbinde kablet under læserens kabinet
- Løsn skruen i bunden af læseren
- Fjern topdækslet
- Udfør ledninger til kontrolpanelet
- Mount the reader on the wall using supplied plastic dowels and screws
- Placer topdækslet og spænd det med en skrue
Installation på metaloverflader kan medføre en reduktion af måleområdet.
Do not place readers closer than 20 cm one from another. It is possible to install tworeaders at a distance 10-15 cm of each other when their yellow wires (Hold/Sync)interconnected. This synchronizes the work of the readers, they will work alternately.
Forbindelse
Seamless and easy connection to existing and new access systems, due to the OSDP, Wiegand 26,32, 34, 37, 40, 42, 56, 58, 64, 80 bits interfaces, Wiegand with automatic selection, RS232 andTouchMemory supports.
We recommend to use multi-core signal cable with 0.22 mm cross-section of each wire betweenreader and panel
Wiegand
Funktionerne for læsertilslutningskablerne er angivet i tabellen.
We recommended to use following whiring when reader connected to the controlpanel with twisted pair.
OSDP
Funktionerne for læsertilslutningskablerne er angivet i tabellen.
We recommended to use following whiring when reader connected to the controlpanel with twisted pair.
RS-232
Funktionerne for læsertilslutningskablerne er angivet i tabellen.
TouchMemory
Funktionerne for læsertilslutningskablerne er angivet i tabellen.
Konfiguration
With the free mobile application U-Prox Config, the reader can be completely adjusted — from theindication to the encryption modes.
U-PROX ID-applikation
Free mobile application U-PROX ID receives, stores and transmits mobile credentials between thereader and the smartphone.
Sådan får du mobil-ID
Du kan købe mobil-ID'er hos vores forhandlere
RFID, 125 kHz
Læseren understøtter 125 kHz kort med amplitude (ASK – EmMarine, etc.) and frequency modulation (FSK – Temik, etc.)|
Disse kort har ikke kloningsbeskyttelse, men er meget populære på grund af deres lave pris.
Mifare®-identifikatorer
The reader supports work with Mifare® cards, reads encrypted identifiers with a user-assigned card number, with a static or diversified encryption key.
Op til fem krypteringsprofferfiles kan bruges samtidigt.
Mifare®Classic
Den mindst sikre serie af kort har en sårbarhed i krypteringsalgoritmen Crypto 1 (SL1).
Når du bruger det, anbefales det at kryptere alle kortsektorer med en diversificeret krypteringsnøgle.
Mifare®Plus
Læseren understøtter SL1- og SL3-tilstande for Mifare®Plus. Det anbefales at bruge SL3-tilstanden, da den har den højeste sikkerhed og AES-krypteringsalgoritme.
Mifare®Defire
Læseren understøtter Mifare DESFire EV1-, EV2- og EV3-kort. AES-krypteringsalgoritmen understøttes.
Garanti
Garantien for U-PROX-enheder (undtagen batterier) er gyldig i to år efter købsdatoen. Hvis enheden fungerer forkert, kontakt venligst support@u-prox.systems i første omgang kan det måske løses eksternt.
Dokumenter/ressourcer
 |
U PROX U-PROX SE KEYPAD Universal Reader With OSDP and Keypad [pdfBrugermanual SE KEYPAD, U-PROX SE KEYPAD Universal Reader With OSDP and Keypad, U-PROX, SE KEYPAD Universal Reader With OSDP and Keypad, Universal Reader With OSDP and Keypad, and Keypad, Keypad |