U PROX U-PROX SE KEYPAD Universal Reader Nrog OSDP thiab Keypad
Specifications:
- Khoom siv: U-PROX SE KEYPAD
- Nta: Universal nyeem ntawv nrog OSDP thiab keypad
- Interfaces: OSDP, Wiegand 26, 32, 34, 37, 40, 42, 56, 58, 64,80 bits, RS232, TouchMemory
- Txhawb nqa: Mifare DESFire EV1, EV2, EV3 cards
- Encryption: AES encryption algorithm
- Warranty: Two years (except batteries)
Cov lus qhia siv khoom
Kev teeb tsa:
- Make a small recess or hole (diameter is 14 mm) to connect the cable under the reader’s case.
- Loosen cov ntsia hlau nyob hauv qab ntawm tus nyeem ntawv.
- Tshem lub hau saum toj kawg nkaus.
- Ua cov kab txuas mus rau lub vaj huam sib luag.
- Mount the reader on the wall using supplied plastic dowels and screws.
- Muab lub hau npog sab saum toj thiab khi nws nrog ib lub ntsia hlau.
Nco tseg: Avoid installing on metal surfaces to prevent a decrease in reading range. Maintain a minimum distance of 20 cm between readers unless interconnected with yellow wires for synchronized operation.
Kev sib txuas:
Use multi-core signal cable with 0.22 mm² cross-section of each wire between reader and panel for seamless connection. Various interfaces like OSDP, Wiegand, RS232, and TouchMemory are supported.
Configuration:
Utilize the U-Prox Config mobile application for adjusting reader settings, including indication and encryption modes. To set the engineering password, connect inputs D0 (green) and D1 (white) and apply power to the reader. Firmware updates can be done with an NFC-enabled Android smartphone.
Mobile Identification:
The U-PROX ID application facilitates receiving, storing, and transmitting mobile credentials between the reader and smartphone.
Mobile IDs tuaj yeem yuav los ntawm cov neeg muag khoom tso cai.
RFID, 125 kHz:
While these cards lack cloning protection, they are cost-effective. For enhanced security, it is recommended to encrypt all card sectors with a diversified encryption key. The reader supports Mifare DESFire EV1, EV2, and EV3 cards with AES encryption.
Kev piav qhia
U-PROX SE keypad – the adjustable universal SmartLine reader with a wireless keypad for mobilecredentials and proximity identifiers.
In conjunction with the U-PROX ID application and mobile identifiers U-PROX IDs allow any accesscontrol system to use smartphones as access system credentials.
Kev teeb tsa
- Ua kom me me los yog qhov (inch yog 14 mm) los txuas cable hauv qab tus nyeem ntawv rooj plaub
- Loosen cov ntsia hlau nyob hauv qab ntawm tus nyeem ntawv
- Tshem lub hau saum toj kawg nkaus
- Ua cov kab txuas mus rau lub vaj huam sib luag
- Mount the reader on the wall using supplied plastic dowels and screws
- Muab lub hau npog sab saum toj thiab khi nws nrog ib lub ntsia hlau
Installation on the metal surfaces may cause decrease of reading range.
Do not place readers closer than 20 cm one from another. It is possible to install tworeaders at a distance 10-15 cm of each other when their yellow wires (Hold/Sync)interconnected. This synchronizes the work of the readers, they will work alternately.
Kev sib txuas
Seamless and easy connection to existing and new access systems, due to the OSDP, Wiegand 26,32, 34, 37, 40, 42, 56, 58, 64, 80 bits interfaces, Wiegand with automatic selection, RS232 andTouchMemory supports.
We recommend to use multi-core signal cable with 0.22 mm cross-section of each wire betweenreader and panel
Wiegand
Tus nyeem ntawv txuas xov hlau ua haujlwm tau teev nyob rau hauv lub rooj.
We recommended to use following whiring when reader connected to the controlpanel with twisted pair.
OSDP
Tus nyeem ntawv txuas xov hlau ua haujlwm tau teev nyob rau hauv lub rooj.
We recommended to use following whiring when reader connected to the controlpanel with twisted pair.
RS-232
Tus nyeem ntawv txuas xov hlau ua haujlwm tau teev nyob rau hauv lub rooj.
TouchMemory
Tus nyeem ntawv txuas xov hlau ua haujlwm tau teev nyob rau hauv lub rooj.
Kev teeb tsa
With the free mobile application U-Prox Config, the reader can be completely adjusted — from theindication to the encryption modes.
Daim ntawv thov U-PROX ID
Free mobile application U-PROX ID receives, stores and transmits mobile credentials between thereader and the smartphone.
Yuav ua li cas kom tau txais mobile ID
Koj tuaj yeem yuav mobile IDs los ntawm peb cov neeg muag khoom
RFID, 125 kHz
Tus nyeem ntawv txhawb 125 kHz phaib nrog amplitude (ASK – EmMarine, etc.) and frequency modulation (FSK – Temik, etc.)|
Cov ntawv no tsis muaj kev tiv thaiv cloning, tab sis yog nrov heev vim lawv cov nqi qis
Mifare® identifiers
The reader supports work with Mifare® cards, reads encrypted identifiers with a user-assigned card number, with a static or diversified encryption key.
Up to five encryption profiles tuaj yeem siv ib txhij.
Mifare® Classic
The least secure series of cards, has a Crypto 1 (SL1) encryption algorithm vulnerability.
When using it, it is recommended to encrypt all card sectors with a diversified encryption key.
Mifare®Plus
Tus nyeem ntawv txhawb SL1 thiab SL3 hom rau Mifare®Plus. Nws raug pom zoo kom siv SL3 hom vim nws muaj kev ruaj ntseg siab tshaj plaws thiab AES encryption algorithm.
Mifare®Defire
Tus nyeem ntawv txhawb Mifare DESFire EV1, EV2 thiab EV3 phaib. AES encryption algorithm tau txais kev txhawb nqa.
Warranty
Warranty rau U-PROX cov khoom siv (tshwj tsis yog roj teeb) siv tau rau ob xyoos tom qab hnub yuav khoom. Yog tias lub cuab yeej ua haujlwm tsis raug, thov hu rau support@u-prox.systems thaum xub thawj, tej zaum nws yuav daws tau remotely.
Cov ntaub ntawv / Cov ntaub ntawv
 |
U PROX U-PROX SE KEYPAD Universal Reader Nrog OSDP thiab Keypad [ua pdf] Tus neeg siv phau ntawv SE KEYPAD, U-PROX SE KEYPAD Universal Reader Nrog OSDP thiab Keypad, U-PROX, SE KEYPAD Universal Reader Nrog OSDP thiab Keypad, Universal Reader Nrog OSDP thiab Keypad, thiab Keypad, Keypad |