QUIO-logo

QUIO QU-RDT2-HF Touch Keypad LCD Display Reader

QUIO-QU-RDT2-HF-Touch-Keypad-LCD-Display-Reader-product-image

Impormasyon sa Produkto

  • Ngalan sa Produkto: QU-RDT2-HF
  • Deskripsyon: Pindota ang Keypad LCD Display Reader
  • Numero sa Modelo: V0103

Mga detalye

Espesipiko / Butang QU-RDT2-HF
Pagbalhin Kasagaran 125KHz / 13.56MHz
Basaha ang Range 5~10cm / 2~6cm
Baud Rate 19,200 bps (4,800~230,400 bps)
Pagkaangay sa Card EM o ISO14443A/B/15693/Mifare
Panahon sa Pagbasa sa Card 0.1Sec
Keypad 12 nga yawe
LED Indicator 3 LED (RGB)
ID sa komunikasyon RS485 ug Wiegand (26/32/34/42/66 Bits)
LCD Display 128×64 Dots (16×4 Char) LCD nga adunay backlight
Anti-Tamper Pasilidad Gitukod-sa (IR)
Beep Tone Gitukod nga Buzzer
Pagsulod Voltage 8V~28V DC / 0.5 ~ 2W
Dimensyon (W x H x D) 89.4 x 124 x 12 mm

Mga Instruksyon sa Paggamit sa Produkto

Nota sa Pag-instalar:
Kini nga produkto naggamit sa usa ka touch panel. Sa pag-instalar ug pagpahugot sa mga screw, sunda kini nga mga lakang:

  1. I-off ang device sulod sa labing menos 5 ka segundo.
  2. Niini nga panahon, ayaw hikapa ang touch panel o ibutang ang bisan unsa niini.
  3. Human sa panahon sa power off, i-reboot ang device.

Kini nga pamaagi gikinahanglan alang sa panel calibration ug recalculation sa touch control function aron masiguro ang husto ug tukma nga operasyon.

QU-RDT2-HF Instruksyon:

Setup:

  • Login: # + # + 0 + 1 (Beep) + PIN + # (Pabrika PIN: 1234)
  • Pag-logout: # + # + 0 + 0 (Beep)

Setup sa ID:

  • Pag-login una, dayon buhata ang mosunod nga mga setting:
  • Set ID: # + # + 0 + 2 (Beep) + ID (Factory ID: 1)
  • Itakda ang Petsa ug Oras: # + # + 0 + 3 (Beep) + YYYYMMDDhhnnss (eg, 20110129032523 para sa Enero 29, 2011, 03:25:23)
  • Usba ang Login PIN: # + # + 0 + 4 (Beep) + Bag-ong PIN
  • Itakda ang Paglangan sa Backlight: # + # + 0 + 5 (Beep) + Oras (0 para sa light steady, 1-250 segundos)
  • Itakda ang Interface: # + # + 0 + 6 (Beep) + Interface (0 para sa Wiegand, 1 para sa RS485, 2 para sa Wiegand & RS485, Pabrika: 2)
  • Itakda ang Pinulongan: # + # + 0 + 7 (Beep) + Pinulongan (0 para sa English, 1 para sa Chinese, Factory: 0 – English)
  • Ibutang ang Encode: # + # + 0 + 8 (Beep) + Encode (0 para sa UNICODE, 1 para sa BIG5, 2 para sa GB2312, Pabrika: 0 – UNICODE)
  • Ibutang ang Status: # + # + 0 + 9 (Beep) + Klase (0 para sa Disable, 1 para sa Enable, Factory: 0 – Disable)

Usba ang kahimtang sa trabaho:

  • Pagsugod sa Trabaho: # + 1 (Beep)
  • Tapuson ang Trabaho: # + 2 (Beep)

Pagbiya sa katungdanan:

  • # + 3 (Beep)

Palihug i-enable ang Status Function una.

Balik alang sa Katungdanan:

  • Pagsugod sa Overtime: # + 4 (Beep)
  • Tapuson ang Overtime: # + 5 (Beep)
  • # + 6 (Beep)

QU-RDT2-HF Detalye

Espesipiko / Butang QU-RDT2-HF

  • Pagbalhin Kasagaran 125KHz / 13.56MHz
  • Basaha ang Range 5~10cm / 2~6cm
  • Baud Rate 19,200 bps (4,800~230,400 bps)
  • Pagkaangay sa Card EM o ISO14443A/B/ 15693 / Mifare
  • Panahon sa Pagbasa sa Card 0.1Sec
  • Keypad 12 nga yawe
  • LED Indicator 3 LED (RGB)
  • Komunikasyon RS485 ug Wiegand (26/32/34/42/66 Bits)
  • ID  0001 ~ 9,999
  • LCD Display 128×64 Dots (16×4 Char) LCD nga adunay backlight
  • Anti-Tamper Gitukod nga Pasilidad (IR)
  • Beep Tone Gitukod nga Buzzer
  • Operating Temperatura -10˚C ~ 60˚C
  • Pagsulod Voltage 8V~28V DC / 0.5 ~ 2W
  • Dimensyon (P x H x D) 89.4 x 124 x 12 mm

Hinumdomi ang Pag-instalar

  • Kini nga produkto naggamit sa touch panel. kung imong gi-install ug gihugot ang mga tornilyo, palihug POWER OFF sa 5 segundos, ug niining panahona,
  • PALIHUG AYAW ibutang ang bisan unsa sa touch panel(eg Finger..etc) unya reboot.
  • Kini nga pamaagi alang sa panel calibration ug recalculation sa touch control function, aron masiguro nga kini mahimo nga husto ug tukma

Mga Instruksyon sa QU-RDT2-HF
QUIO-QU-RDT2-HF-Touch-Keypad-LCD-Display-Reader-02 QUIO-QU-RDT2-HF-Touch-Keypad-LCD-Display-Reader-03

Klaro:'✱'

Usba ang kahimtang sa trabaho:QUIO-QU-RDT2-HF-Touch-Keypad-LCD-Display-Reader-04Palihug i-enable ang Status Function una.

QUIO-QU-RDT2-HF-Touch-Keypad-LCD-Display-Reader-01

Quick-Ohm Küpper & Co. GmbH
Cronenfelderstraße 75 | 42349 Wuppertal
Tel: +49 (0) 202 404329 | Fax: +49 (0) 202 404350
E-Mail: kontakt@quio-rfid.de Web: www.quio-rfid.de

Mga Dokumento / Mga Kapanguhaan

QUIO QU-RDT2-HF Touch Keypad LCD Display Reader [pdf] Giya sa Pag-instalar
QU-RDT2-HF Touch Keypad LCD Display Reader, QU-RDT2-HF, Touch Keypad LCD Display Reader, Keypad LCD Display Reader, LCD Display Reader, Display Reader, Reader

Mga pakisayran

Pagbilin ug komento

Ang imong email address dili mamantala. Ang gikinahanglan nga mga natad gimarkahan *