HPBS provides portable car battery jump starters, multi-functional tire inflators, and reliable emergency power banks for automotive roadside assistance.
HPBS is a consumer electronics brand specializing in reliable, portable automotive emergency power solutions. Their primary product lineup features heavy-duty car battery jump starters, offering peak currents ranging from 2000A up to 5000A. These powerful units are designed to safely and efficiently jump-start large gas and diesel engines without the need for a secondary vehicle.
Beyond basic jump-starting, many HPBS devices are engineered as multi-functional travel companions. They frequently integrate extra features such as high-pressure (150 PSI) tire inflators for emergency tire care, high-capacity USB power banks for charging mobile devices, and bright LED flashlights equipped with emergency SOS signaling capabilities.
Explore our library of HPBS user manuals, setup instructions, and troubleshooting guides to ensure you maximize the life of your device and stay prepared for the road.
Latest manuals from manuals+ curated for this brand.
Common questions about manuals, registration, and support for this brand.
Connect the included USB charging cable to the jump starter's USB-C input port and the other end to a USB wall charger adapter or a computer. To maintain battery health, it is recommended to fully charge the unit before first use and recharge it every three months when not in use.
First, ensure the jump starter is charged above 50%. Connect the red smart clamp to the positive (+) terminal of your car battery and the black clamp to the negative (-) terminal. Turn on the jump starter, start your vehicle's engine, and be sure to disconnect the clamps within 30 seconds of a successful start.
If the engine does not start immediately, disconnect the clamps from the battery and wait at least 20 seconds before attempting again to prevent overheating or damage. Limit your start attempts to a maximum of three within a two-minute window.
Press the main power switch to turn the unit on, then press and hold the LED button for more than 3 seconds to turn on the flashlight. You can short-press the button repeatedly to switch between standard illumination, SOS signaling, and strobe flash modes.