zigbee GW70-MQTT 3.0 USB Dongle Plus-E Ṣii Orisun Ailokun Ailokun
Imọ ni pato
| Wireless Communication Frequency: | 2.4GHz-2.48GHz |
| Awọn Ilana ti o ni atilẹyin: | Thread, Zigbee 3.0, Bluetooth 5.2 LE |
| PORT config: | /dev/tty USB0 |
| Idaabobo ESD: | Bẹẹni |
| Awọn ọna ṣiṣe to wulo: | Home Assistant-ZHA, Home Assistant-Zigbee 2Mqtt, Open HAB |
| Ijinna ibaraẹnisọrọ: | 400M (Without obstruction) |
| Signal strength (dbm): | 18.6 (Instrument testing) |
| Antenna gain (dbi): | 0 |
| Maximum supported device number: | 128 |
Awọn ilana Lilo
- Open the package, connect the antenna to the USB port, and then insert it into a Computer / Raspberry Pi /Home Assistant Green etc.
- Enter the corresponding system configuration (Home Assistant/Open HAB) product port (port: /dev/ttyUSB0).
For detailed configuration procedures, please refer to the guidance documents of the corresponding system.
- After configuration is completed, the device can be connected and used.
Awọn Ilana atilẹyin
Of course, you can also extend the network range by using it as a router through re-flashing the firm ware.
Onibara Support
Scan the QR code to learn about the connection between this product and Home Assistant.
Awọn iwe aṣẹ / Awọn orisun
 |
zigbee GW70-MQTT 3.0 USB Dongle Plus-E Ṣii Orisun Ailokun Ailokun [pdf] Afowoyi olumulo GW70-MQTT 3.0 USB Dongle Plus-E Ṣii Orisun Alailowaya Ibudo, GW70-MQTT, 3.0 USB Dongle Plus-E Orisun Ṣiṣii Ailokun Alailowaya, Plus-E Ṣiṣii Orisun Alailowaya, Ibudo Alailowaya Orisun, Ibudo Alailowaya |