zigbee GW70-MQTT 3.0 USB Dongle Plus-E маркази бесими манбаи кушода
Мушаххасоти техникӣ
| Wireless Communication Frequency: | 2.4 ГГц-2.48 ГГц |
| Протоколҳои дастгирӣ: | Thread, Zigbee 3.0, Bluetooth 5.2 LE |
| PORT config: | /dev/tty USB0 |
| Муҳофизати ESD: | Бале |
| Системаҳои татбиқшаванда: | Home Assistant-ZHA, Home Assistant-Zigbee 2Mqtt, Open HAB |
| Масофаи алоқа: | 400M (Without obstruction) |
| Signal strength (dbm): | 18.6 (Instrument testing) |
| Antenna gain (dbi): | 0 |
| Maximum supported device number: | 128 |
Дастурҳои истифода
- Open the package, connect the antenna to the USB port, and then insert it into a Computer / Raspberry Pi /Home Assistant Green etc.
- Enter the corresponding system configuration (Home Assistant/Open HAB) product port (port: /dev/ttyUSB0).
For detailed configuration procedures, please refer to the guidance documents of the corresponding system.
- After configuration is completed, the device can be connected and used.
Протоколҳои дастгирӣшаванда
Of course, you can also extend the network range by using it as a router through re-flashing the firm ware.
Дастгирии муштариён
Scan the QR code to learn about the connection between this product and Home Assistant.
Ҳуҷҷатҳо / Сарчашмаҳо
 |
zigbee GW70-MQTT 3.0 USB Dongle Plus-E маркази бесими манбаи кушода [pdf] Дастури корбар GW70-MQTT 3.0 USB Dongle Plus-E маркази бесими кушода, GW70-MQTT, 3.0 USB Dongle Plus-E маркази бесими кушода, Plus-E маркази бесими манбаи кушода, маркази бесими манбаи бесим, маркази бесим |