zigbee GW70-MQTT 3.0 USB Dongle Plus-E Open Source Wireless Hub
Speċifikazzjonijiet Tekniċi
| Wireless Communication Frequency: | 2.4GHz-2.48GHz |
| Protokolli Appoġġjati: | Thread, Zigbee 3.0, Bluetooth 5.2 LE |
| PORT config: | /dev/tty USB0 |
| Protezzjoni ESD: | Iva |
| Sistemi applikabbli: | Home Assistant-ZHA, Home Assistant-Zigbee 2Mqtt, Open HAB |
| Distanza ta' Komunikazzjoni: | 400M (Without obstruction) |
| Signal strength (dbm): | 18.6 (Instrument testing) |
| Antenna gain (dbi): | 0 |
| Maximum supported device number: | 128 |
Istruzzjonijiet għall-Użu
- Open the package, connect the antenna to the USB port, and then insert it into a Computer / Raspberry Pi /Home Assistant Green etc.
- Enter the corresponding system configuration (Home Assistant/Open HAB) product port (port: /dev/ttyUSB0).
For detailed configuration procedures, please refer to the guidance documents of the corresponding system.
- After configuration is completed, the device can be connected and used.
Protokolli Appoġġjati
Of course, you can also extend the network range by using it as a router through re-flashing the firm ware.
Appoġġ għall-Klijent
Scan the QR code to learn about the connection between this product and Home Assistant.
Dokumenti / Riżorsi
 |
zigbee GW70-MQTT 3.0 USB Dongle Plus-E Open Source Wireless Hub [pdfManwal tal-Utent GW70-MQTT 3.0 USB Dongle Plus-E Open Source Wireless Hub, GW70-MQTT, 3.0 USB Dongle Plus-E Open Source Wireless Hub, Plus-E Open Source Wireless Hub, Source Wireless Hub, Wireless Hub |