Danfoss RET Series Itanna Dial Setting Thermostat pẹlu Itọsọna Fifi sori LCD Ifihan
Awọn ilana fifi sori ẹrọ
| Awọn ẹya ara ẹrọ | RET B (RF) / RET B-LS (RF) / RET B-NSB (RF) |
| Olubasọrọ Rating | 10 – 230 Vac, 3 (1) (excl. North America) |
| Contact rating (N.America) | 10 – 24 Vac, 50/60Hz, 3(1)A |
| Yiye iwọn otutu | ±1°C |
| Olubasọrọ Iru | SPDT Type 1B |
| Atagba igbohunsafẹfẹ | 433.92 MHz (RF models) |
| Atagba ibiti | 30m max (RF models) |
| Ibi ti ina elekitiriki ti nwa | 2 x AA/MN1500 alkaline batteries |
| Iṣakoso idoti Ipo | Ipele 2 |
| Won won Ipa Voltage | 2.5 kV |
| Apẹrẹ lati pade | BS EN 60730-2-9 (EN 300220 for RF) |
| Ball Ipa Igbeyewo | 75°C |
| Iwọn otutu | 5-30°C |
| Awọn iwọn (mm) | 85 fife x 86 giga x 42 jin |
Important note RF products: Ensure that there are no large metal objects, such as boiler cases or other large appliances, in line of sight between the transmitter and receiver as these will prevent communication between thermostat and receiver.
Iṣagbesori
Ṣe atunṣe ni giga ti 1.5m isunmọ lati ilẹ, kuro lati awọn iyaworan tabi awọn orisun ooru gẹgẹbi awọn imooru, awọn ina ṣiṣi tabi imọlẹ orun taara.
Wiring (not RF models)
gbigbona
DIL yipada eto
Slide the DIL switches to the settings required (see below)
Yiyan alapapo
Aṣayan itutu agbaiye
TAN/PA boiler switches ON when below set temperature and OFF when above
CHRONO Ẹya fifipamọ agbara eyiti o tan igbomikana ni awọn aaye arin deede lati ṣetọju iwọn otutu ti a ṣeto, iyọrisi agbegbe ibaramu igbagbogbo fun olumulo.
- lo 6 Awọn iyipo for radiator systems
- lo 3 Awọn iyipo for underfloor heating
Titiipa & Idiwọn
Asopọ olugba (RF nikan)
RX1 & RX2
RX3
Akiyesi: 1) For mains voltage operated systems, link terminal 2 to mains live supply 2) Power supply to unit must not be switched by timeswitch
Commissioning (RF only)
Ti o ba ti pese thermostat ati olugba papo ni idii apapọ, awọn ẹya naa ti so pọ ni ile-iṣẹ ko si nilo ifiṣẹṣẹ (RX1 nikan).
Step 1 RET B-RF
Position the setting dial to number 1. Remove dial, press & hold LEARN button for 3 seconds (located under setting dial).
Do not replace the setting dial yet
AKIYESI: Thermostat now transmits signal continuously for 5 mins.
Igbesẹ 2 RX1
Tẹ mọlẹ awọn bọtini PROG ati CH1 until green light flashes.
Step 3 RX2/RX3
For RX2 or RX3 repeat steps 1 and 2 for each thermostat and channel, leaving at least 5 mins between the commissioning of each thermostat.
Step 4 RET B-RF
To replace the thermostat setting dial, position the dial to number 1.
Awọn ilana
Kini thermostat yara kan?
an explanation for householders. A room thermostat simply switches the heating system on and off as necessary. It works by sensing the air temperature, switching on the heating when the air temperature falls below the thermostat setting, and switching it off once this set temperature has been reached.
Titan thermostat yara kan si eto ti o ga julọ kii yoo jẹ ki yara naa gbona ni iyara eyikeyi. Bi yara yara yara gbona ṣe da lori apẹrẹ ti eto alapapo, fun example, awọn iwọn ti igbomikana ati radiators.
Bẹni eto naa ko kan bii yara yara yoo tutu. Titan thermostat ti yara si eto isalẹ yoo mu ki a ṣakoso yara ni iwọn otutu kekere, ati fi agbara pamọ.
Eto alapapo kii yoo ṣiṣẹ ti iyipada akoko kan tabi oluṣeto eto ba ti pa a.
The way to set and use your room thermostat is to find the lowest temperature setting that you are comfortable with, and then leave it alone to do its job. The best way to do this is to set the room thermostat to a low temperature – say 18°C-and then turn it up by one degree each day until you are comfortable with the temperature. You won’t have to adjust the thermostat further. Any adjustment above this setting will waste energy and cost you more money.
Ti eto alapapo rẹ ba jẹ igbomikana pẹlu awọn imooru, igbagbogbo yara igbagbogbo yoo wa lati ṣakoso gbogbo ile naa. Ṣugbọn o le ni awọn iwọn otutu oriṣiriṣi ni awọn yara kọọkan nipa fifi sori ẹrọ awọn eefun radiator thermostatic (TRVs) lori awọn radiators kọọkan. Ti o ko ba ni awọn TRV, o yẹ ki o yan iwọn otutu ti o jẹ oye fun gbogbo ile. Ti o ba ni awọn TRV, o le yan eto diẹ ti o ga julọ lati rii daju pe paapaa yara ti o tutu julọ ni itunu, lẹhinna ṣe idiwọ eyikeyi igbona ni awọn yara miiran nipa ṣiṣatunṣe awọn TRV.
Awọn igbona yara nilo ṣiṣan ọfẹ ti afẹfẹ lati loye iwọn otutu, nitorinaa wọn ko gbọdọ bo nipasẹ awọn aṣọ -ikele tabi dina nipasẹ ohun -ọṣọ. Awọn ina ina nitosi, awọn tẹlifisiọnu, ogiri tabi tabili lamps le ṣe idiwọ thermostat lati ṣiṣẹ daradara.
Awọn Itọsọna olumulo
Ifihan
The LCD displays actual room temperature until the setting dial is moved.
Ṣiṣeto iwọn otutu
Turn setting dial to required temperature. The selected temperature will filasi in the LCD to signify it is showing ṣeto otutu.
After a short period the display stops flashing and shows actual room temperature.
Thermostat status (heat mode only)
Aami ina kan yoo tan nigbakugba ti thermostat n pe fun ooru.
Thermostat status (cool mode only)
A snowflake symbol will be lit whenever the thermostat is calling for cooling. If this is seen to flash, the thermostat output is delayed for a short period to prevent compressor damage.
Itọkasi batiri kekere
A battery symbol will flash in the display when batteries require replacement. Batteries should be replaced within 15 days, after which the thermostat will turn off the load it is controlling.
When this happens “Of” will be displayed.
PATAKI: alkaline batteries must be used.
RET B-LS model only
This model is fitted with an Auto/Off switch.
When the switch is set in “I” position the thermostat controls at the temperature set by the setting dial.
When set to “O” the thermostat output is turned off and “Of” is displayed.
RET B-NSB model only
This model is fitted with a Day / Night yipada.
When the switch is set to the “Sun Symbol”, the thermostat controls at the temperature set by the setting dial.
When set to the “Moon symbol”, the thermostat controls at 4°C below the temperature set by the setting dial.
AKIYESI: if used to control cooling, thermostat controls 4°C higher, with switch in MOON position.
www.danfoss.com/Business Areas/Heating
Ọja yii ni ibamu pẹlu awọn itọsọna EC wọnyi:
Ilana Ibamu Electro-Magnetic.
(EMC) (891336/EEC), (92\31\EEC)
Kekere Voltage Itọsọna.
(LVD) (73\23\EEC), (93/68/EEC)
Awọn iwe aṣẹ / Awọn orisun
 |
Danfoss RET Series Electronic Dial Setting Thermostat with LCD Display [pdf] Fifi sori Itọsọna RET B RF, RET B-LS RF, RET B-NSB RF, RET Series Electronic Dial Setting Thermostat with LCD Display, Electronic Dial Setting Thermostat with LCD Display, Dial Setting Thermostat with LCD Display, Thermostat with LCD Display, LCD Display |
