Vortex M SSK Mechanical Keyboard

USER GUIDE

Mechanical Keyboard

Before proceeding with the assembly, please take note of the following reminders and precautions:

1. When installing the switches, please be careful and gentle, especially with the five-pin switches, to avoid damaging the hot-swap sockets during the process.
2.The stabilizers shown in the following picture belong to us. The kit does not include the stabilizers when shipped, so please prepare it on your own.

Step 1

Use the hex key to unscrew the case (M2 black screw * 8).

Mechanical Keyboard

Step 2

After disassembling the top and bottom case, secure the daughterboard at the marked locations in the picture below, and attach the gaskets according to preference.

Mechanical Keyboard

Step 3

Place the brass standoffs at the marked locations in the picture below and secure them in position by screwing in six pieces of brass standoffs from the front of the mounting plate. Utilize the included flat-head screws found in the zip bag for this process.

Mechanical Keyboard

 

Mechanical Keyboard

Step 4

Place the poron switch pad and poron plate foam sequentially onto the PCBA, with the Poron switch pad positioned first, followed by the Poron plate foam.

Mechanical Keyboard

Step 5

Place the mounting plate (FR-4/brass/aluminum) on top of the Poron plate foam.

Mechanical Keyboard

Step 6

After positioning the mounting plate, flip it over to the backside of the PCB, and secure the previously installed brass standoffs by fastening them with screw

Mechanical Keyboard

 

Mechanical Keyboard

Step 7

Flip the top case of the kit to the back and position the Poron plate foam, followed by the Poron switch pad along the F-row. Finally, place the PCB on top. Then screin the M2 black screw*4 pcs.

Mechanical Keyboard

 

Mechanical Keyboard

Step 8

Turn the main PCB over and insert the FFC (Flexible flat cable) into the connector. *Please make sure to insert the FFC at the very bottom (blue side facing up, with the metal side facing down) Close the cover once it is inserted.

Mechanical Keyboard

Step 9

Place the poron bottom foam on the top of the bottom case.

Mechanical Keyboard

Step 10

Connect the main PCB with the daughterboard and attach the ffc to the F-row. Place the top case and secure it with M2 black screw* 8 pcs to complete the assembly.

Mechanical Keyboard

 

Mechanical Keyboard

Specifications:

  • Model: M SSK Kit
  • Switch Compatibility: Five-pin switches
  • Included Components: Brass standoffs, Poron switch pad, Poron plate foam, Mounting plate (FR-4/brass/aluminum), FFC (Flexible flat cable)

FAQ

Q: Are stabilizers included in the kit?

A: No, stabilizers are not included in the kit. Please prepare them separately.

Documents / Resources

Vortex M SSK Mechanical Keyboard [pdf] User Guide
Model M SSK Kit, M SSK Mechanical Keyboard, M SSK, Mechanical Keyboard, Keyboard

References

Leave a comment

Your email address will not be published. Required fields are marked *