THINKYA A11 CD Player
WHAT’S IN THE BOX
PRODUCT SPECIFICATIONS
| Product name | CD Player |
| Input power | DC SV/2A |
| Bluetooth version | 5.0 |
| BT protocol support | ADP/AVRCP |
| BT receiving distance | 1OM |
| Battery capacity | 3.6V/2600mAh |
| Output Power | speaker(4Q)2X2W;earphone(16Q)2X20mW |
| USB playback format | MP3/WMA/WAV/APE/FLAC |
| CD playback format | CD-DA/MP3/CD-R |
| Audio In | 3.5mm Audio In |
| Analog audio output | 3.5mm stereo headphone output |
| Charging cable length | 80CM |
| Product Size | 210X170X77mm |
| Product weight | about 985g |
| Product accessories | (chargingcable. audiocable. manual. remote)x1 |
- COLORED LANTERN
- LONG PRESS: STANDBY
SHORT PRESS:ON/IN PUT SOURCE SELECTION(CD,USB,AUX,BT) - LONG PRESS: JUMPTOTHE PREVIOUS LIGHTING EFFECT
SHORT PRESS: PREVIOUS - LONG PRESS : JUMPTOTHE NEXT LIGHTING EFFECT
- SHORT PRESS:NEXT
VOLUME BUTTON - TONEARM SWITCH(PLAY/PAUSE)
REAR PANEL CONNECTIONS
- OPTICAL FIBER OUTPUT
- AUX AUDIO INPUT TERMINAL
- HEADPHONES OUTPUTTERMINAL
- U SB INPUT TERMINAL
- TYPE-C POWER TERMINAL
- SWITCH
LED DISPLAY
- BLUETOOTH
- USB
- CD
- POWER
- SINGLE LOOP
- TRACK NUMBER
- ALL LOOP
- RAND
- PLAYTIME(SECONDS)
- AUX
REMOTE CONTROLLER
- STANDBY/ON
- VOLUME+
- PREVIOUS
- VOLUME
- REPEAT/SHUFFLE
- BASS+/
- BT TRANSMITTING SIGNAL
- MUTE
- NEXT
- PLAY /PLAUSE
- STOP
- INPUT SOURCE SELECTION (BT/AUX/CD/USB)
- TREBLE+/-
- EQ
POWER ON/STANDBY
- Turn the switch to ON state button 6 on the rear panel
- To turn on the unit, click the STANDBY button 2 on the button panel
- To put the unit into standby mode, long-press the STANDBY button once again
BLUETOOTH MODE
Select the Bluetooth mode. Click the SOURCE (button2) on the button panel until the BT option appears on the screen.The light will start flashing,which means the unit is ready to pair
US B-MP3
Plug the desired USB in the USB input slot of the rear panel
Devices compatible with USB 2.0 , Size 32Gb
Select the USB mode. using the button panel (SOURCE button 2)
PLAYING CDS
Select the CD mode. Using the button panel (SOURCE button 2)
Insert the CD into the tray
To search for a section on a CD track, press the NEXT (button 4 or PREVIOUS (button 3) during playback,then release it at the point you want to listen
FCC STATEMENT
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Documents / Resources
 |
THINKYA A11 CD Player [pdf] User Guide A11, A11 CD Player, CD Player, Player |
