THINKYA A11 CD Player User Guide

THINKYA-LOGO

THINKYA A11 CD Player

THINKYA-A11-CD-Player-PRODUCT

WHAT’S IN THE BOX

THINKYA-A11-CD-Player-FIG-1

THINKYA-A11-CD-Player-FIG-2PRODUCT SPECIFICATIONS

Product name CD Player
Input power DC SV/2A
Bluetooth version 5.0
BT protocol support ADP/AVRCP
BT receiving distance 1OM
Battery capacity 3.6V/2600mAh
Output Power speaker(4Q)2X2W;earphone(16Q)2X20mW
USB playback format MP3/WMA/WAV/APE/FLAC
CD playback format CD-DA/MP3/CD-R
Audio In 3.5mm Audio In
Analog audio output 3.5mm stereo headphone output
Charging cable length 80CM
Product Size 210X170X77mm
Product weight about 985g
Product accessories (chargingcable. audiocable. manual. remote)x1

BUTTON PANEL CONTROLS

THINKYA-A11-CD-Player-FIG-3

  1. COLORED LANTERN
  2. LONG PRESS: STANDBY
    SHORT PRESS:ON/IN PUT SOURCE SELECTION(CD,USB,AUX,BT)
  3. LONG PRESS: JUMPTOTHE PREVIOUS LIGHTING EFFECT
    SHORT PRESS: PREVIOUS
  4. LONG PRESS : JUMPTOTHE NEXT LIGHTING EFFECT
  5. SHORT PRESS:NEXT
    VOLUME BUTTON
  6. TONEARM SWITCH(PLAY/PAUSE)

REAR PANEL CONNECTIONS

THINKYA-A11-CD-Player-FIG-4

  1. OPTICAL FIBER OUTPUT
  2. AUX AUDIO INPUT TERMINAL
  3. HEADPHONES OUTPUTTERMINAL
  4. U SB INPUT TERMINAL
  5. TYPE-C POWER TERMINAL
  6. SWITCH

LED DISPLAY

THINKYA-A11-CD-Player-FIG-5

  1. BLUETOOTH
  2. USB
  3. CD
  4. POWER
  5. SINGLE LOOP
  6. TRACK NUMBER
  7. ALL LOOP
  8. RAND
  9. PLAYTIME(SECONDS)
  10. AUX

REMOTE CONTROLLER

  1. STANDBY/ON
  2. VOLUME+
  3. PREVIOUS
  4. VOLUME­
  5. REPEAT/SHUFFLE
  6. BASS+/­
  7. BT TRANSMITTING SIGNAL
  8. MUTE
  9. NEXT
  10. PLAY /PLAUSE
  11. STOP
  12. INPUT SOURCE SELECTION (BT/AUX/CD/USB)
  13. TREBLE+/-
  14. EQ

THINKYA-A11-CD-Player-FIG-7

POWER ON/STANDBY

THINKYA-A11-CD-Player-FIG-8

  1. Turn the switch to ON state button 6 on the rear panelTHINKYA-A11-CD-Player-FIG-9
  2. To turn on the unit, click the STANDBY button 2 on the button panel
  3. To put the unit into standby mode, long-press the STANDBY button once again

THINKYA-A11-CD-Player-FIG-10BLUETOOTH MODE

THINKYA-A11-CD-Player-FIG-11

Select the Bluetooth mode. Click the SOURCE (button2) on the button panel until the BT option appears on the screen.The light will start flashing,which means the unit is ready to pairTHINKYA-A11-CD-Player-FIG-12

THINKYA-A11-CD-Player-FIG-13US B-MP3

THINKYA-A11-CD-Player-FIG-14

Plug the desired USB in the USB input slot of the rear panelTHINKYA-A11-CD-Player-FIG-15

Devices compatible with USB 2.0 , Size 32Gb

Select the USB mode. using the button panel (SOURCE button 2)

THINKYA-A11-CD-Player-FIG-16PLAYING CDS

THINKYA-A11-CD-Player-FIG-17

Select the CD mode. Using the button panel (SOURCE button 2)

Insert the CD into the tray

THINKYA-A11-CD-Player-FIG-18

To search for a section on a CD track, press the NEXT (button 4 or PREVIOUS (button 3) during playback,then release it at the point you want to listen

FCC STATEMENT

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Statement

The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Documents / Resources

PDF thumbnailA11 CD Player
User Guide · A11, A11 CD Player, CD Player, Player

References

Questions and answers

Helpful product questions tied to this manual. Each item links to the full Q&A page.

Questions & Answers

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

  1. 買って2ヶ月目で、充電してもつかなくなりました
    叩いたり落としたり雑に扱ったことは一切ありません
    丁寧に棚に置いてあったのですが、つかなくなりました

    ユーザー asks 買って2ヶ月目で、充電してもつかなくなりました
    叩いたり落としたり雑に扱ったことは一切ありません
    丁寧に棚に置いてあったのですが、つかなくなりました
    Manuals+ clarified question
    Question

    My THINKYA A11 CD player will not turn on even after charging, despite being handled carefully for two months. How can I fix this?

    Answer

    If your THINKYA A11 CD player is not turning on after charging, please try the following troubleshooting steps based on the manual's power instructions:

    • Check the Physical Power Switch: Ensure the main power switch on the rear panel is toggled to the ON state. The device will not power up or charge correctly if this switch is off.
    • Verify the Standby Mode: After turning the rear switch on, you must click the STANDBY button (labeled as button 2 on the top control panel) to fully wake the unit.
    • Inspect the Charging Connection: The manual specifies a DC 5V/2A input. Ensure you are using a compatible Type-C charging cable and a power adapter that meets these specifications. Try a different cable or wall outlet to rule out a faulty charger.
    • Reset the Device: If the unit is unresponsive, try toggling the rear power switch OFF and then ON again to perform a hard reset.

    Since you mentioned the device is only two months old and has been handled carefully, if these steps do not work, it may indicate an internal battery or hardware failure. We recommend contacting the seller or THINKYA support regarding warranty options.

  2. 2025年6月ぐらいに買ったもので、電源は入るけど、CDにしても動かない。充電をしながらも聞けない。どうしたらいいの?

    伊藤香織 asks 2025年6月ぐらいに買ったもので、電源は入るけど、CDにしても動かない。充電をしながらも聞けない。どうしたらいいの?
    Manuals+ clarified question
    Question

    The CD player powers on but will not play CDs, even when charging. What should I do?

    Answer

    If your THINKYA A11 powers on but fails to play CDs, please try the following troubleshooting steps based on the user guide:

    • Check the Mode: Ensure the device is set to CD mode. Press the SOURCE button (button 2 on the panel) until the "CD" icon appears on the LED display.
    • Verify Disc Placement: Ensure the CD is inserted correctly into the tray. The player supports CD, CD-DA, CD-R, and CD-RW formats.
    • Power Switch: Confirm the physical power switch on the rear panel is in the ON position before using the STANDBY button on the top panel to wake the device.
    • Charging Requirements: The device requires a DC 5V/2A input. If you are using a low-power phone charger or a computer USB port, it may not provide enough current to operate the motor while charging. Try using a higher-amperage power adapter.
    • Tonearm/Switch: Ensure the tonearm switch (Play/Pause) is being engaged correctly as per the "Playing CDs" section of the manual.

    If the unit still does not spin the disc despite being in the correct mode and having sufficient power, there may be a hardware fault with the optical drive or internal battery circuit.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.