soundcore X600 Motion Portable Bluetooth Speaker User Guide

To pair the speaker with a Bluetooth device, enable Bluetooth on your device, then press the Bluetooth button on the speaker. Once connected, the status will show “PAIRING CONNECTED.”

You can toggle the Spatial Sound and BassUp features by pressing the corresponding buttons on the speaker.

Adjust the volume using the Volume Up and Volume Down buttons.
Play or pause music by pressing the Play/Pause button.

Charge the speaker using the USB-C Charging Input. You can also connect external devices using the AUX IN port.

Overview

Power
Bluetooth

Spatial Sound
BassUp

Volume Down
Play/Pause

Volume Up
USB-C Charging Input

AUX IN

Battery Instructions

Powering On/Off

Bluetooth Pairing

Spatial Sound and BassUp Features

Volume Control and Playback

Charging and Connectivity

More Information

Reset

Important Safety Information

Please read this user manual carefully and save it for future reference.

Do not place naked flame sources, such as lighted candles, on or near the product.
Clean only with a dry cloth. Do not use any corrosive cleaner or oil.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any heat sources, such as radiators, heat registers, stoves, or other apparatus.
Only use attachments/accessories specified by the manufacturer.
Operating temperature should be between 0°C to 40°C/32°F to 104°F.
Do not make unauthorized alterations to the product; doing so may compromise safety, regulatory compliance, system performance, and may void the warranty.
Servicing is required when the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
The product contains a battery pack, so it should not be exposed to excessive heat such as sunshine, fire or the like.

WARNING: Use only power supplies / attachments / accessories specified by the manufacturer.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Notice

This product complies with the radio interference requirements of the European Community.

Declaration of Conformity

Hereby, Anker Innovations Limited declares that this product is in compliance with Directives 2014/53/EU & 2011/65/EU and amendment (EU) 2015/863.
The full text of the EU declaration of conformity is available at the following internet address:
https://support.soundcore.com/s/articleRecommend?type=DownLoad&secondType=doc

Maximum output power: 10 dBm
Frequency band: 2.4G band (2.402GHz-2.480GHz)

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.
This symbol indicates “separate collection” for all batteries and accumulators. Danger of explosion if battery is incorrectly replaced. To reduce risk of fire, explosion or leakage of flammable liquid/gas, don’t disassemble, crush, puncture, short external contacts, expose to temperature above 60°C (140°F), sunshine or like, expose to extremely low air pressure or dispose of in fire or water. Replace only with specified batteries.

High or low extreme temperatures that a battery can be subjected to during use, storage or transportation:

During use: maximum 40℃ (104°F)
Storage: -20 – 45℃ (-4 – 113°F)

Transportation: 5 – 35℃ (41 – 95°F)

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and

this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

The highest SAR value reported under this standard during product certification for use next to the body/limb with the minimum separation distance of 0 mm. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter.

Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 7973

IC NOTICE TO CANADIAN USERS
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

IC Radio Frequency Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been tested in accordance with the measurement methhods and procedures specified in IEEE 1528 and IEC 62209. This equipment should be installed and opperated with minimum distance 0 mm between the radiator and your body/limb. This device and itsantenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

CAN ICES-003 (B) / NMB-003 (B)

This Class B digital apparatus complies with Canadian ICES-003.

Additional Legal Rights for Consumers

For consumers, who are covered by consumer protection laws or regulations in their country of purchase or, if different, their country of residence, the benefits conferred by soundcore’s Limited Warranty are in addition to all rights and remedies conveyed by such consumer protection laws and regulations, including but not limited to these additional rights.
For FAQs and more information, please visit https://www.soundcore.com/.

The power delivered by the charger must be between min [0.1] Watts required by the radio equipment, and max [15] Watts in order to achieve the maximum charging speed.

Hereby, Anker Innovations Limited declares that this device is in compliance with The Product Security and Telecommunications Infrastructure (Security Requirements for Relevant Connectable Products) Regulations 2023. For the Statement of Compliance, visit the website: https://uk.soundcore.com/pages/psti-related.

CONTACT

service@soundcore.com
support.mea@soundcore.com (For Middle East and Africa Only)
support@anker.com

+1 (800) 988 7973 (US/Canada)
+44 (0) 1604 936200 (UK)
+49 (0) 69 9579 7960 (DE)

03 4455 7823
+86 400 0550 036
+82 02-1661-9246

+971 520750842 (Middle East & Africa)
+971 8000320817 (UAE)
+966 8008500030 (KSA)

+965 22069086 (Kuwait)
+20 8000000826 (Egypt)

The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Anker Innovations Limited (or Anker Technology Co., Limited) is under license.
Other trademarks and trade names are those of their respective owners.

Anker Innovations Limited | Unit 56, 8th Floor, Tower 2, Admiralty Centre, 18 Harcourt Road, Hong Kong
The following importer is the responsible party (contract for EU and UK matters):
Anker Technology (UK) Limited | GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom
Anker Innovations Deutschland GmbH | Georg-Muche-Strasse 3, 80807 Munich, Germany

For FAQs and more information, please visit: soundcore.com/support

FAQ

Q: How long is the warranty for the soundcore Motion X600?
- A: The product comes with an 18-month limited warranty and lifetime technical support.
Q: How do I reset the speaker?
- A: To reset, press and hold the Reset button for more than 8 seconds.
Q: Where can I find more information or support for this product?
- A: Visit soundcore.com/support or contact the respective support email/phone numbers provided in the manual.

Documents / Resources

soundcore X600 Motion Portable Bluetooth Speaker [pdf] User Guide
A3130, 51005005115, X600 Motion Portable Bluetooth Speaker, Motion Portable Bluetooth Speaker, Portable Bluetooth Speaker, Bluetooth Speaker, Speaker

References

User Manual

soundcore X600 Motion Portable Bluetooth Speaker

Product Information

Product Usage Instructions