Push Switch RF Remote Controller
Model No.: R1-1(L)
R1-1(L) Push Switch RF Remote Controller
RF dimming/Push dim/Wall junction box mounting
User Manual
Ver 1.0.3
Features
- Apply to single color LED RF controller or RF dimming driver.
- Connect with push switch to achieve on/off and 0-100% dimming function.
- Adopt 2.4GHz wireless technology, remote distance up to 30m.
- Each remote can match one or more receiver. CR2032 button battery powered.
Technical Parameters
Input and Output
Output signal | RF (2.4GHz) |
Working voltage | 3VDC |CR2032| |
Working current | <5mA |
Standby current | <2μA |
Standby time | 2 years |
Remote distance | 30m(Barrier-free space) |
Warranty
Warranty | 5 years |
Safety and EMC
EMC standard (EMC) | ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4 |
Safety standard(LVD) | EN 62368-1:2020+A11:2020 |
Radio Equipment(RED) | ETSI EN 300 328 V2.2.2 |
Certification | CE,EMC,LVD,RED |
Environment
Operation temperature | Ta: -30 ºC ~ +55 ºC |
IP rating | IP20 |
Dimension
Battery Installation
Wiring diagram
Push switch function:
- Short press: Turn on/off light.
- Long press(1-6s): When light is on, increase or decrease brightness continuously.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match:
Short press match key, immediately press the push switch.
The LED indicator fast flash a few times means match is successful.
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again.
Immediately short press the push switch 3 times.
The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power, repeat again.
Immediately short press the push switch 5 times.
The light blinks 5 times means all matched remotes were deleted.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery. - If no response from the receiver, please re-match the remote.
- For indoor and dry location use only.
Documents / Resources
![]() |
Sage R1-1 L Push Switch RF Remote Controller [pdf] User Manual R1-1 L, Push Switch RF Remote Controller, R1-1 L Push Switch RF Remote Controller, Switch RF Remote Controller, RF Remote Controller, Remote Controller, Controller |