Lumiso Pooltest Expert Photometer
User Guide
Registration and technical support
Thank you for choosing a Palintest Lumiso Pooltest Expert Photometer. Please register your instrument now at www.palintest.com/products/lumiso-pooltest-expert or scan
the QR Code.
https://www.palintest.com/products/lumiso-pooltest-expert/
There, you will also find invaluable support for your new instrument, including:
- User Manual
- Supporting documents for all test methods
- Firmware updates
- Palintest Connect cloud based data storage and management
Getting started
Onscreen instructions are available for all test methods.
Achieving accurate results
Blanking
- Blanking is critical and sets the zero level for each test.
- Usually, the blank is a sample without any reagents added.
- The onscreen instructions show blanking as the first few steps, however, the “blank” can be prepared in a separate tube and blankingcarried out just prior to the measurement step.
Best practice when testing
 |
||
| Rinse equipment thoroughly with deionised water or the water being tested. | Measure volumes accurately as shown (or use a pipettor or syringe). | Use the correct Palintest reagents and observe all safety information supplied with them. |
 |
||
| Check for bubbles and remove as shown. | Align tubes as shown. Always use the tube cap as it excludes light from the optics. |
Keep instrument clean. Dry all tubes before placing in the optical cell. |
Verify instrument calibration
Check Standards are available for your Lumiso Pooltest Expert. Use these regularly to confirm that the instrument is within calibration.
www.palintest.com©Palintest Limited 2022. All rights reserved.
egistered office: Palintest House, Kingsway, Team Valley,
Tyne & Wear, England NE11 0NS.
Registered in England, Number 1204118
ZIINSTLMPX V1
Documents / Resources
 |
Palintest Lumiso Pooltest Expert Photometer [pdf] User Guide Lumiso Pooltest Expert, Photometer, Lumiso Pooltest Expert Photometer, ZIINSTLMPX V1 |
