VEX 249-8581 AIM Coding Robot

Zvinotsanangurwa

• Robot Model: 249-8581 VEX AIM Coding Robot
• Mutevedzeri Mutevedzeri: 269-8230-000 One Stick Controller
• Robhoti Li-ion Bhatiri Model: NSC1450 (3.7V/800mAh/2.96Wh)
• Controller Li-ion Battery Model: HFC1025 (3.2V/100mAh/0.32Wh

Mirayiridzo Yekushandiswa Kwechigadzirwa

Kubatanidza One Stick Controller kune AIM Robot:

1. Simba paAIM Robot.
2. Tarisa kuti Robot iri muBluetooth mode:
   • Tarisa chiratidzo chesimba rechiratidzo kuratidza Bluetooth Mode.
   • Kana iri muWIFI Mode:
     1. Go to the Settings menu and press the icon.
     2. Go to the Wi-Fi menu and press the icon.
     3. Press the Wi-Fi On icon to turn Wifi off.
     4. Verify the Robot is in Bluetooth mode by checking the signal strength icon.
3. Enda kune Settings.
4. Go to Link Controller and Press the Icon.
5. The screen should display once the AIM Robot is in pairing mode.
6. Double-tap tap Power Button on the One Stick Controller to put it in pairing mode.
7. LED should turn orange once the One Stick Controller is in pairing mode.
8. LED should blink green once the controller is paired with the AIM Robot.
9. AIM Robot should show signal strength in the top left corner when connected to the One Stick Controller.

Kusvika kune e-label:

1. Simba paAIM Robot.
2. Dzvanya iyo Settings icon.
3. Dzvanya About icon.
4. Iyo e-label icon icharatidzwa.

CHENJERERO:

• Risk of fire and burns. Do not open, crush, heat above 60°C, or incinerate.
• Do not recharge a battery pack that shows signs of leakage or corrosion.
• Usarase bhatiri mumoto.
• Inofanira kuraswa zvakanaka.
• Usaite short-circuit.
• Never charge batteries unattended or without adult supervision. Do not heat or set a battery on fire.
• Do not disassemble or refit the battery.

Controller Li-ion Battery Model: HFC1025 (3.2V/100mAh/0.32Wh)

YAMBIRO:

• KUCHENGA DZIVA - Zvidiki zvidiki.
• Kwete kuvana vari pasi pemakore matatu.

Yambiro: KUCHENGA DZIVA - Zvidiki zvidiki.

vxxrobotics.com Ages 8+ Ans 8+

Bhatani uye Joystick Test

Pair the One Stick Controller to the AIM Robot

1. Simba paAIM Robot.
2. Verify the Robot is in Bluetooth mode.
   a. Tarisa chiratidzo chesimba icon kuti uone Bluetooth Mode, enderera kunhanho 3.b. Tarisa chiratidzo chesimba icon kuti uone WIFI Mode.
   1. Go to the Settings menu and press the icon.
   2. Go to Wifi menu and press the icon.
   3. Press the “Wifi On” icon to turn Wifi off.
   4. The following icon should be displayed.
   5. Then press the green checkmark to save settings.
   6. Verify the Robot is in Bluetooth mode by checking the signal strength icon.
3. Enda kune Settings.
4. Go to Link Controller and Press the Icon.
5. The screen below should be displayed once the AIM Robot is in pairing mode.
6. Double-tap the Power Button to put the One Stick Controller in pairing mode.
7. LED should turn orange once the One Stick Controller has entered pairing mode.
8. LED should blink green once the controller is paired with the AIM RoboThe t.
9. AIM Robot should show signal strength in the top left corner when connected to the Once Stick Controller.

Kusvika kune e-label

1. Simba paAIM Robot.
2. Dzvanya marongero icon.
3. Dzvanya About icon.
4. The following icon is displayed.

Custom manufactured in China for Innovation First Trading SARL. Distributed in the U.S.A.A., Mexico, Caribbean, Central & South America by VEX Robotics, Inc., 6725 W. FM 1570, Greenville, TX 75402, U.S.A. Distributed in China by Innovation First International (Shenzhen), Ltd., Suite 1205, Galaxy Development Center, 18 Zhongxin 5th Road, Futian, Shenzhen, Guangdong, China 518048. Distributed in other regions by Innovation First Trading SARL, Z.A.E. Wolser G, 315, 3434 – Dudelange, Luxembourg +352 27 86 04 87. Distributed in Canada by / Distribuè au Canada par / Innovation First Trading, LLC, 6725 W. FM 1570, Greenville, TX 75402, U.S.A. ©2024 VEX Robotics, Inc. All rights reserved. Tous droits réservés.

FCC Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and operated according toed by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

Ngatitii mudziyo uyu unokonzera kukanganisa kunokuvadza paredhiyo kana terevhizheni, izvo zvinogona kutariswa nekudzima nekubatidza. Muchiitiko ichocho, mushandisi anokurudzirwa kuti aedze kugadzirisa kukanganiswa neimwe kana akawanda eanotevera matanho:

• Reorrent kana kutamisa antenna inogamuchira.
• Wedzera kupatsanurwa pakati pemidziyo nemugamuchiri.
• Batanidza midziyo kune yekubuda padunhu rakasiyana neiyo iyo mugamuchiri akabatanidzwa.
• Bvunza mutengesi kana nyanzvi yeredhiyo/TV ine ruzivo kuti ubatsirwe.

Chirevo cheFCC:
Ichi chishandiso chinoenderana nechikamu 15 cheFCC Mitemo. Kushanda kunoenderana nemamiriro maviri anotevera: (1) Muchina uyu haugone kukonzera kukanganisa kunokuvadza, uye (2) mudziyo uyu unofanirwa kugamuchira chero kukanganiswa kunowanikwa, kusanganisira kukanganisa kunogona kukonzera kushanda kwausingadi. Yambiro: Shanduko kana gadziridzo kuchikamu ichi chisina kutenderwa nebato rine chekuita nekutevedzwa zvinogona kukanganisa mvumo yemushandisi yekushandisa michina.

Industry Canada Compliance Statement
Iyi dhijitari yeKirasi B inowirirana neCanada ICES-003.

Kushanda kunoenderana nemamiriro maviri anotevera:

1. Mudziyo uyu unogona kusakonzera kukanganisa.
2. Muchina uyu unofanirwa kugamuchira chero kukanganisa, kusanganisira kukanganisa kunogona kukonzera kushanda kusingade kwemudziyo.

Mudziyo uyu une marezenisi ekutumira(ma)/vatambi anowirirana neInnovation, Science and Economic Development Canada's rezinesi-exempt RSS(s). Kushanda kunoenderana nemamiriro maviri anotevera: (1) Ichi chishandiso chinogona kusakonzera kukanganisa. (2) Ichi chishandiso chinofanirwa kubvuma chero kukanganisa, kusanganisira kukanganisa kunogona kukonzera kushanda kusingadiwe kwechigadzirwa

Kuti uwane rumwe ruzivo uye kuti utange nekiti yako, tarisa iyo QR kodhi kuti utange dzidzisaAIM.vex.com

FAQS

• Mubvunzo: Ndinotarisa sei mabhatiri emhando yeRobhoti uye Mutongi?
  A: The Robot Li-ion Battery Model is NSC1450 (3.7V/800mAh/2.96Wh) and the Controller Li-ion Battery Model is HFC1025 (3.2V/100mAh/0.32Wh).
• Mubvunzo: Ndingaona sei kana Robot iri muBluetooth mode?
  A: Check the signal strength icon on the Robot to determine if it is in Bluetooth mode. If not, follow the steps to switch from WIFI Mode to Bluetooth Mode as outlined in the instructions.

Zvinyorwa / Zvishandiso

VEX 249-8581 AIM Coding Robot [pdf] Bhuku reMuridzi 249-8581-750, 249-8581, 249-8581-000, 269-8230-000, 249-8581 AIM Coding Robot, 249-8581, AIM Coding Robot, Coding Robot, Robot

References

• User Manual