WS1 وائي فائي گرمي پد سينسر
“
پيداوار جي وضاحت
| ماڊل | بجلي جي فراهمي | وڌ موجوده | ماپ جي حد | درستگي | قرارداد | تحفظ جي سطح | ڳنڍيندڙ | ڪيبل ڊگھائي | ڪميونيڪيشن پروٽوڪول | RS485 ايڊريس | بيڊ جي شرح |
|---|---|---|---|---|---|---|---|---|---|---|---|
| يو بي-ايس اي سي-اين 1 | ڊي سي 4.5 ~ 30V | — | soil+60%+25) EC: 1S/cm Temperature: 0.1 Humidity: 0.1% | — | — | IP68 | آڊيو | 3m | RS485 Modbus RTU پروٽوڪول | 0x ڊي 6 | 1200 bit/s, 2400 bit/s, 4800 bit/s (default), 9600 bit/s, 19200 بي پي ايس |
پيداوار جي استعمال جون هدايتون
ماپ جي ايراضي
Measurement area: Inside a 5cm diameter cylinder of equal height
to the probes, centered on the center of the two probes.
Ground Penetration Method
Vertically dig a pit with a diameter of >20cm. Insert the
sensor pin horizontally into the pit wall at the established depth
and fill the pit tightly. After a period of stabilization,
measurements and recordings can be made over a period of days,
months, or even longer.
ڪميونيڪيشن پروٽوڪول
1. ڪميونيڪيشن جا بنيادي پيرا ميٽر
- ڪوڊنگ سسٽم ڊيٽا بٽ
- Parity Checking Bit Stop Bit Error Checking Baud Rate 1200
bit/s, 2400 bit/s, 4800 bit/s (default), 9600 bit/s, 19200
بي پي ايس
2. ڊيٽا فريم فارميٽ
Modbus-RTU ڪميونيڪيشن پروٽوڪول ھيٺ ڏنل ۾ استعمال ٿيندو آھي
فارميٽ:
- شروعاتي جوڙجڪ: وقت ۾ 4 بائيٽ.
- Address code: 1 byte, default 0xE1.
- فنڪشن ڪوڊ: 1 بائيٽ، سپورٽ فنڪشن ڪوڊ 0x03 (صرف پڙهڻ لاءِ)
۽ 0x06 (پڙهڻ/لکڻ). - ڊيٽا جو علائقو: اين بائيٽ، 16-بٽ ڊيٽا، اعلي بائيٽ پهريون اچي ٿو.
- غلطي چيڪ ڪريو: 16-bit CRC ڪوڊ.
- آخري جوڙجڪ: وقت جا 4 بائيٽ.
3. رجسٽر ايڊريس
| پتو | وصف |
|---|---|
| 0x0000 | Humidity (Unsigned integer data, divided by 10) |
| 0x0001 | Temperature (Signed integer data, divided by 10) |
| 0x0002 | EC Address Baud Rate Register Address Register Length Function Code (Integer 1255) |
نوٽ:
- The probe must be fully inserted into the soil when
ماپڻ. - Pay attention to lightning protection when using in the
ميدان. - Do not violently bend the probe, do not pull the sensor lead
wire, do not drop or hit the sensor.
اڪثر پڇيا ويندڙ سوال (FAQ)
Q: How deep should the sensor be inserted into the soil for
accurate measurements?
A: The sensor should be fully inserted into the
soil for accurate measurements.
عبرت: ڇا sensor ٻاهرين ماحول ۾ استعمال ڪري سگهجي ٿو؟
A: Yes, the sensor can be used in outdoor
environments. However, it is important to pay attention to
lightning protection when using it in the field.
Q: What is the communication protocol used by the sensor?
A: The sensor uses RS485 Modbus RTU Protocol
رابطي لاء.
“`
پيداوار جو تعارف
The sensor, with its stable performance and high sensitivity, is an important tool for observing and studying the occurrence, evolution and improvement of saline soils and water-salt dynamics. Measurement of the dielectric constant of the soil provides a direct and stable reflection of the true water content of various soils, as well as a measurement of the volume percentage of soil moisture.
Use Case Scenarios The sensor is suitable for soil moisture monitoring, scientific experiments, water-saving irrigation, greenhouses, flowers and vegetables, meadows and pastures, rapid soil measurement, plant cultivation, wastewater treatment, fine agriculture and other occasions.
Features 1. Soil water content, conductivity and temperature in one. 2. Completely sealed, acid and alkali corrosion resistant, can be buried in the soil or directly into the
water for long-term dynamic detection. 3. High precision, fast response, good interchangeability, probe insertion design ensures accurate
measurement and reliable performance.
پيداوار جي وضاحت
ماڊل پاور سپلائي وڌ ۾ وڌ موجوده ماپڻ جي حد
درستگي
Resolution Protection level
ڪنيڪٽر ڪيبل جي ڊيگهه ڪميونيڪيشن پروٽوڪول RS485 پتو
بيڊ جي شرح
وضاحتون
يو بي-ايس اي سي-اين 1
ڊي سي 4.5 ~ 30V
110mA@5V EC: 0~20000S/cm Temperature: -40~80 Humidity: 0~100% EC: ±3%FS (0~10000S/cm), ±5%FS (10000~20000S/cm) Temperature: ±0.5 Humidity: ±2% (@0~50%, palm soil+30%+25) ; ±3% (@50~100%, palm
soil+60%+25) EC: 1S/cm
Temperature: 0.1 Humidity: 0.1% IP68
آڊيو
3m
RS485 Modbus RTU پروٽوڪول
0x ڊي 6
1200 بِٽ/سڪ، 2400 بِٽ/سڪ، 4800 بِٽ/سڪ (ڊفالٽ)، 9600 بِٽ/سڪ، 19200 بِٽ/سڪ
وائرنگ جي هدايت
Measurement Area Measurement area: Inside a 5cm diameter cylinder of equal height to the probes, centred on the centre of the two probes.
Quick Test Method Select a suitable measurement site, avoid rocks and ensure that the steel needle does not touch hard objects. Throw away the top layer of soil according to the required measuring depth, keep the original tightness of the soil underneath, and insert the sensor vertically into the soil by holding it tightly. Do not shake the sensor from side to side when inserting it. It is recommended to take several measurements within a small area of one measurement point to find the average value.
Ground Penetration Method Vertically dig a pit with a diameter of >20cm. Insert the sensor pin horizontally into the pit wall at the established depth and fill the pit tightly. After a period of stabilisation, measurements and recordings can be made over a period of days, months or even longer.
ڪميونيڪيشن پروٽوڪول
1. رابطي جا بنيادي پيرا ميٽر
ڪوڊنگ سسٽم ڊيٽا بٽ
برابري چيڪنگ بِٽ اسٽاپ بِٽ
باڊ ريٽ چيڪ ڪرڻ ۾ غلطي
ڪميونيڪيشن جو بنيادي پيرا ميٽر 8 بِٽ بائنري 8 بِٽ ڪون 1 بِٽ سي آر سي چيڪ
1200 بِٽ/ايس، 2400 بِٽ/ايس، 4800 بِٽ/ايس (ڊفالٽ)، 9600 بِٽ/ايس، 19200 بِٽ/ايس
2. ڊيٽا فريم فارميٽ
Modbus-RTU ڪميونيڪيشن پروٽوڪول هيٺ ڏنل شڪل ۾ استعمال ٿيندو آهي:
شروعاتي جوڙجڪ وقت ۾ 4 بائيٽ.
Address code: 1 byte, default 0xE1.
فنڪشن ڪوڊ: 1 بائيٽ، سپورٽ فنڪشن ڪوڊ 0x03 (صرف پڙهڻ لاءِ) ۽ 0x06 (پڙهڻ/لکڻ لاءِ).
ڊيٽا جو علائقو: اين بائيٽ، 16-بٽ ڊيٽا، اعلي بائيٽ پهريون اچي ٿو.
غلطي چيڪ ڪريو: 16-bit CRC ڪوڊ.
4 بائيٽ وقت جي جوڙجڪ کي ختم ڪريو.
درخواست
غلام جو پتو
فنڪشن ڪوڊ رجسٽر ايڊريس رجسٽرن جو تعداد
CRC LSB
CRC MSB
1 بائيٽ
1 بائيٽ
2 بائيٽ
2 بائيٽ
1 بائيٽ
1 بائيٽ
جواب
غلام ايڊريس فنڪشن ڪوڊ نمبر بائيٽس مواد 1 مواد 1
…
مواد اين
سي آر سي
1 بائيٽ
1 بائيٽ
1 بائيٽ
2 بائيٽ
2 بائيٽ
…
2 بائيٽ
2 بائيٽ
3. رجسٽر ايڊريس
Address 0x0000 0x0001 0x0002 0x07D0 0x07D1
Content Humidity Temperature
EC Address Baud Rate
رجسٽر ايڊريس
رجسٽر جي ڊيگهه فنڪشن ڪوڊ
1
03
1
03
1
03
1
03/06
1
03/06
وصفن جي وضاحت غير دستخط ٿيل عدد ڊيٽا، 10 سان ورهايل
Signed integer data, divided by 10 Integer 1255
0:2400, 1:4800, 2:9600
NOTE 1. The probe must be fully inserted into the soil when measuring. 2. Pay attention to the lightning protection when using in the field. 3. Do not violently bend the probe, do not pull the sensor lead wire, do not drop or hit the sensor
تشدد سان.
دستاويز / وسيلا
 |
UBiBOT WS1 Wifi Temperature Sensor [pdf] استعمال ڪندڙ ھدايت WS1, WS1 Pro, UB-SEC-N1, WS1 Wifi Temperature Sensor, WS1, Wifi Temperature Sensor, Temperature Sensor, Sensor |