ROLL-A-SHADE RASPSORMLVER.2 Plus Shade Open Roll

ROLL-A-SHADE RASPSORMLVER.2 Plus Shade Open Roll

HARDWARE INCLUDED

  • Shade + Clutch + Chain + Tension Device
    Hardware Included
  • Brackets
    Hardware Included
  • Bracket Covers
    Hardware Included
  • #14 Screw
    Hardware Included
  • Screws
    Hardware Included

TOOLS REQUIRED

  • 3/8” Hex Head
    Tools Required
  • Phillips Head
    Tools Required
  • 1/8” Drill Bit
    Tools Required
  • Drill
    Tools Required

CLICK TO PRINT

INSIDE OR OUTSIDE APPLICATION

**NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON
ARRIVAL**

Inside Or Outside Application
Inside Or Outside Application

MOUNTING LOCATION

Place your first bracket in its mounting location and mark the screw holes. Place your second bracket in its mounting location and repeat the process.

Mounting Location

SCREW INSTALLATION

Next, pre-drill your screw holes using a 1/8” drill bit. Install the brackets with the provided screws using the 1/4” hex head driver.

Screw Installation

ALIGNMENT

Check to make sure your brackets are level and aligned.

Alignment

SHADE PIN END INSTALLATION

Depress pin end and slide onto bracket until pin engages in center hole. Press idler shaft all the way to the bracket.

Shade Pin End Installation

CLUTCH END & TENSION DEVICE INSTALLATION

Lineup to clutch bracket. Push clutch into clutch bracket. Install tension device.

Clutch End & Tension Device Installation

COMPLETED INSTALLATION

Completed Installation

ROLL-A-SHADE RASPSORMLVER.2 Plus Shade Open Roll

TENSION DEVICE

INSTALLATION INSTRUCTIONS

HARDWARE INCLUDED

  • Tension Device + Chain
    Hardware Included
  • Tension Device Bracket
    Hardware Included
  • Short Screws
    Hardware Included
  • Screws
    Hardware Included

TOOLS REQUIRED

  • 3/8” Hex Head
    Tools Required
  • Phillips Head
    Tools Required
  • 1/8” Drill Bit
    Tools Required
  • Drill
    Tools Required

CLICK TO PRINT

INSIDE OR OUTSIDE APPLICATION

Inside Or Outside Application
INSIDE
Inside Or Outside Application
OUTSIDE
Inside Or Outside Application

INSIDE MOUNT & TENSION DEVICE INSTALLATION

Pull the Chain hold down until the chain is fully tensioned (plunger will be fully raised). Screw device into wall.

Inside Mount & Tension Device Installation
Inside Mount & Tension Device Installation
Inside Mount & Tension Device Installation

NOTE: Please make sure shade operates smoothly.

OUTSIDE MOUNT & TENSION DEVICE INSTALLATION

With provided screws, install bracket first with large screws (use Chain hold marked screw hole locations as reference). Pull the Chain hold down until the chain is fully tensioned (plunger will be fully raised). Install Chain hold into bracket with small screws.

Outside Mount & Tension Device Installation Outside Mount & Tension Device Installation
Outside Mount & Tension Device Installation Outside Mount & Tension Device Installation
Outside Mount & Tension Device Installation Outside Mount & Tension Device Installation

Customer Support

Rollashade.com
info@rollashade.com
951.245.5077

© Copyright Roll A Shade® Inc. All Rights Reserved.

Logo

Documents / Resources

ROLL-A-SHADE RASPSORMLVER.2 Plus Shade Open Roll [pdf] Instruction Manual
RASPSORMLVER.2 Plus Shade Open Roll, RASPSORMLVER.2 Plus, Shade Open Roll, Open Roll

References

Leave a comment

Your email address will not be published. Required fields are marked *