ROLL-A-SHADE RAS Plus Shade Open Roll

ROLL-A-SHADE RAS Plus Shade Open Roll

HARDWARE INCLUDED

  • Shade + Motor
    Hardware Included
  • Brackets
    Hardware Included
  • Bracket Covers
    Hardware Included
  • Wall Switch
    Hardware Included
  • Switch Box
    Hardware Included
  • #14 Screw
    Hardware Included
  • Screws
    Hardware Included
  • Zip Ties
    Hardware Included
  • Wire Tie Pads
    Hardware Included

TOOLS REQUIRED

  • 3/8” Hex Head
    Tools Required
  • Phillips Head
    Tools Required
  • 1/8” Drill Bit
    Tools Required
  • Drill
    Tools Required

CHECK TO PRINT

INSIDE OR OUTSIDE APPLICATION

  • NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL**
    Inside Or Outside Application

MOUNTING LOCATION

  • Place your first bracket in its mounting location and mark the screw holes. Place your second bracket in its mounting location and repeat the process.
    Mounting Location

SCREW INSTALLATION

  • Next, pre-drill your screw holes using a 1/8” drill bit. Install the brackets with the provided screws using the 1/4” hex head driver.
    Screw Installation

ALIGNMENT

  • Check to make sure your brackets are level and aligned.Alignment

SHADE PIN END INSTALLATION

  • Depress pin end and slide onto bracket until pin engages in center hole. Press idler shaft all the way to the bracket.
    Shade Pin End Installation

MOTOR END INSTALLATION

  • Lineup to motor bracket. Push motor into motor bracket.
    Motor End Installation

PLUG IN MOTOR

  • Run motor power cord to nearest power outlet.
  • Install wire tie pads and secure with zip ties to hold wire down.
  • The path of the wire should be parallel with mullions and/or drop ceiling tiles ensuring the cable is neatly organized.
  • Any modifications to the power cable should be done by a certified electrician to meet your city/state code requirements.
    Shade Adjusting (If Necessary)

SHADE ADJUSTING (IF NECESSARY)

  • Roll shade up and down to confirm hembar is level and material rolls up straight on center tube.
  • If the hembar is not level, lower shade until you see the metal tube.
  • Add layers of masking tape to the metal tube to the end that is too low until hembar is straight.
  • If the material tracks to one side, lower shade until you see the metal tube.
  • Add layers of masking tape to the metal tube to the end that is opposite the direction of tracking, until shade rolls up straight.
    Shade Adjusting (If Necessary)

ADJUSTING LIMITS (IF NECESSARY)

See programming instructions based on the motor used for your application.

CUSTOMER SUPPORT

RASPSORMVER.3 5 OF 5 | © Copyright Roll A Shade®
Inc. All Rights Reserved.

Rollashade.com
info@rollashade.com
951.245.5077

© Copyright Roll A Shade®
Inc. All Rights Reserved.

Logo

Documents / Resources

ROLL-A-SHADE RAS Plus Shade Open Roll [pdf] Instruction Manual
RAS Plus Shade Open Roll, RAS Plus, Shade Open Roll, Open Roll

References

Leave a comment

Your email address will not be published. Required fields are marked *