Roll A Shade - Commercial Window Shade Solutions
Instruction Manual for ROLL-A-SHADE models including: RASPSORMLVER.2 Plus Shade Open Roll, RASPSORMLVER.2 Plus, Shade Open Roll, Open Roll
RASTDV2VER.2 4 OF 4 | © Copyright Roll A Shade Inc. All Rights Reserved. OUTSIDE MOUNT & TENSION DEVICE INSTALLATION With provided screws, install bracket first ...
File Info : application/pdf, 9 Pages, 1.62MB
DocumentDocumentPLUS+ SHADE OPEN ROLL MANUAL INSTALL ATION INSTRUCTIONS Rollashade.com info@rollashade.com 951.245.5077 © Copyright Roll A Shade® Inc. All Rights Reserved. HARDWARE INCLUDED Shade + Clutch + Chain + Tension Device Brackets Bracket Covers #14 Screw Screws TOOLS REQUIRED 3/8" Hex Head Phillips Head 1/8" Drill Bit Drill 1 INSIDE OR OUTSIDE APPLICATION **NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL** OUTSIDE INSIDE INSIDE OUTSIDE RASPSORMLVER.2 2 OF 5 | © Copyright Roll A Shade® Inc. All Rights Reserved. 2 MOUNTING LOCATION Place your first bracket in its mounting location and mark the screw holes. Place your second bracket in its mounting location and repeat the process. A. B. C. 3 SCREW INSTALLATION Next, pre-drill your screw holes using a 1/8" drill bit. Install the brackets with the provided screws using the 1/4" hex head driver. RASPSORMLVER.2 3 OF 5 | © Copyright Roll A Shade® Inc. All Rights Reserved. 4 ALIGNMENT Check to make sure your brackets are level and aligned. 5 SHADE PIN END INSTALLATION Depress pin end and slide onto bracket until pin engages in center hole. Press idler shaft all the way to the bracket. A B 5 CLUTCH END & TENSION DEVICE INSTALLATION Lineup to clutch bracket. Push clutch into clutch bracket. Install tension device. A. B. C. RASPSORMLVER.2 4 OF 5 | © Copyright Roll A Shade® Inc. All Rights Reserved. 11 COMPLETED INSTALLATION RASPSORMLVER.2 5 OF 5 | © Copyright Roll A Shade® Inc. All Rights Reserved. TENSION DEVICE INSTALL ATION INSTRUCTIONS Rollashade.com info@rollashade.com 951.245.5077 © Copyright Roll A Shade® Inc. All Rights Reserved. HARDWARE INCLUDED Tension Device + Chain Tension Device Bracket Short Screws Screws INSIDE OR OUTSIDE APPLICATION OUTSIDE INSIDE TOOLS REQUIRED 3/8" Hex Head Phillips Head 1/8" Drill Bit Drill INSIDE OUTSIDE RASTDV2VER.2 2 OF 4 | © Copyright Roll A Shade® Inc. All Rights Reserved. INSIDE MOUNT & TENSION DEVICE INSTALLATION Pull the Chainhold down until the chain is fully tensioned (plunger will be fully raised). Screw device into wall. A B KEEP TENSION C SECURE TENSION DEVICE NOTE: Please make sure shade operates smoothly. RASTDV2VER.2 3 OF 4 | © Copyright Roll A Shade® Inc. All Rights Reserved. OUTSIDE MOUNT & TENSION DEVICE INSTALLATION With provided screws, install bracket first with large screws (use Chainhold marked screw hole locations as reference). Pull the Chainhold down until the chain is fully tensioned (plunger will be fully raised). Install Chainhold into bracket with small screws. A B PULL CHAIN DOWN & MARK LOCATION C REMOVE TENSION DEVICE & DRILL D E PLACE TENSION DEVICE ON BRACKET F SECURE TENSION DEVICE NOTE: Please make sure shade operates smoothly. RASTDV2VER.2 4 OF 4 | © Copyright Roll A Shade® Inc. All Rights Reserved.