MADJAX 03-167 Grab Handle
INSTALLATION INSTRUCTIONS
03-168: One Piece Automotive Style Grab Handle
STEP 1
Insert allen head bolt into the grab handle and thread on the ‘T’ nut onto the end of the bolt.
STEP 2
Align the ‘T’ nuts with the inside wide track as shown.
STEP 3
Using a 6mm allen wrench, tighten the allen head bolt ensuring the ‘T’ nut engages on the triple track top.
STEP 4
Tighten the allen head hand tight to ensure the grab handle is secure to the top and use supplied plugs to cover bolt holes.
03-167: Round Grab Handle with Nylon Strap
STEP 1
Install the ‘T’ studs into the inside wide track and turn to engage with track.
STEP 2
Place grab handle mounting bracket onto the ‘T’ studs with the flat side facing out, as shown in Step 3.
STEP 3
Thread the supplied locknut onto the ‘T’ studs as shown and adjust the grab handle to desired width.
STEP 4
Using a 13mm socket, hand-tighten down the locknut securely, ensuring the ‘T’ stud is fully engaged with the track.
Note: Self-tapping screws included for optional installation locations.
Documents / Resources
![]() |
MADJAX 03-167 Grab Handle [pdf] Instruction Manual 03-167 Grab Handle, 03-167, Grab Handle, Handle |