GRACE Grab Rail Instruction Manual

GRACE Grab Rail Instruction Manual
GRACE Grab Rail

Instruction Guide

  1. Mark your holes using a pencil.
  2. Using a Ø 4.5 mm drill bit, drill holes 40 mm deep.
    Instruction
  3. Insert screw into the holes  and tighten them using the spanner provided.
  4. Slide and twist cover until its flush with the wall
    Instruction

IMPORTANT INFORMATION

Before Installing please identify that you have all the kit parts as listed below.

Proper fitting of this item is extremely important.

This is suitable for DIY fitments however if the necessary tools and expertise are not available, we would recommend installation by a qualified tradesperson.

Ensure your wall is in sound condition prior to fitting.

The screws provided are for wood only or for use with suitable plastic wall plugs.

Ensure that no hidden pipes or cables will interfere when installing.

Ensure that eye protection is worn throughout the installation.

Kit Parts Included

  • Grab Rail
    Grab Rail
  • 6x Screws
    Screws
  • Spanner
    Spanner

Tools for installation

  • Power Drill
    Power Drill
  • Optional Spirit Level
    Optional
  • Pencil
    Pencil
  • 4.5mm Drill bit
    Drill bit
  • Optional Measuring Tape
    Measuring Tape

Company logo

Documents / Resources

PDF thumbnailGrab Rail
Instruction Manual · Grab Rail, Rail

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.