MADJAX GRABHANDLES

STEP 1

Insert allen head bolt into the grab handle and thread on the 'T' nut onto the end of the bolt.

STEP 2

Align the 'T' nuts with the inside wide track as shown.

[Image description: A diagram showing T-nuts being aligned with the inside wide track of a vehicle's roof or frame.]

STEP 3

Using a 6 mm allen wrench, tighten the allen head bolt ensuring the 'T' nut engages on the triple track top.

STEP 4

Tighten the allen head hand tight to ensure the grab handle is secure to the top and use supplied plugs to cover bolt holes.

[Image description: A grab handle secured to the vehicle top, with plugs being inserted into the bolt holes.]

STEP 3

Using a 6 mm allen wrench, tighten the allen head bolt ensuring the 'T' nut engages on the triple track top.

STEP 4

Tighten the allen head hand tight to ensure the grab handle is secure to the top and use supplied plugs to cover bolt holes.

[Image description: A close-up view of the grab handle installation, showing the T-nut engaged with the track and a plug covering a bolt hole.]

STEP 1

Install the 'T' studs into the inside wide track and turn to engage with track.

[Image description: T-studs being inserted and turned to engage with the vehicle's track system.]

STEP 2

Place grab handle mounting bracket onto the 'T' studs with the flat side facing out, as shown in Step 3.

STEP 3

Thread the supplied locknut onto the 'T' studs as shown and adjust the grab handle to desired width.

STEP 4

Using a 13mm socket, hand-tighten down the locknut securely, ensuring the 'T' stud is fully engaged with the track.

[Image description: A locknut being tightened onto a T-stud using a 13mm socket, securing the grab handle bracket.]

Note: Self-tapping screws included for optional installation locations.

[Image description: An arrow pointing outwards with the text "FACING OUTWARD" indicating the orientation of the grab handle bracket.]