Z-Wave Protocol Implementation Conformance Statement
MultiSensor 6
General Information
- Product Identifier: ZW100-C
- Brand Name: Aeotec
- Product Version: HW: 100 FW: 1.08
- Z-Wave Certification #: ZC10-16065113
Product Features
- Firmware Updatable: Updatable by Consumer by RF
- IP (Ingress Protection) Rated: Yes
- Battery Type: CR123A
- Battery Quantity: 2
- Sensors: Air Temperature, Humidity, Luminance, Motion/No Motion (Binary), Ultraviolet Index, Vibration/Shock (Binary)
Z-Wave Product Information
- Supports Z-Wave Beaming Technology?: Yes
- Supports Z-Wave Network Security?: Yes
- Supports Z-Wave AES-128 Security S0?: No
- Supports Security S2?: No
- SmartStart Compatible?: No
Z-Wave Technical Information
- Z-Wave Frequency: CEPT (Europe)
- Z-Wave Product ID: 0x0064
- Z-Wave Product Type: 0x0002
- Z-Wave Hardware Platform: ZM5101
- Z-Wave Development Kit Version: 6.51.06
- Z-Wave Library Type: Enhanced 232 Slave
- Z-Wave Device Type / Role Type: Multilevel Sensor / Reporting Sleeping Slave
Association Group Information
Group # / Max Nodes: 1/5
The MultiSensor supports 1 association group. Group 1 is assigned to the Lifeline association group and can add max 5 association nodes. When the PIR motion sensor is triggered, the MultiSensor will send Basic Set (0xFF) to the associated nodes. If no PIR motion is triggered after the PIR interval time (configurable), the MultiSensor will send Basic Set (0x00) to the associated nodes. The automatically reports of temperature, humidity, luminance and ultraviolet (configurable) also can be sent to the associated nodes.
Controlled Command Classes (1): Basic
