Z-Wave Protocol Implementation Conformance Statement

General Information

• Product Identifier: ZW132-B
• Brand Name: Aeotec
• Product Version: HW: 132 FW: 1.01
• Z-Wave Certification #: ZC10-17035484

Product Features

• Switch Type: Toggle
• Firmware Updatable: Updatable by Consumer by RF
• Electric Load Type: Dimmable LED, ELV (Electronic), Fluorescent, Incandescent, Inductive (e.g. Motor), LED, MLV (Magnetic)
• Supported Meter Type: Electric Energy
• Z-Wave Scene Type: Scene

Z-Wave Product Information

• Supports Z-Wave Beaming Technology?: Yes
• Supports Z-Wave Network Security?: Yes
• Supports Z-Wave AES-128 Security S0?: Yes
• Supports Security S2?: No
• SmartStart Compatible?: No

Z-Wave Technical Information

• Z-Wave Frequency: Australia / New Zealand
• Z-Wave Product ID: 0x0084
• Z-Wave Product Type: 0x0203
• Z-Wave Hardware Platform: ZM5101
• Z-Wave Development Kit Version: 6.51.09
• Z-Wave Library Type: Enhanced 232 Slave
• Z-Wave Device Type / Role Type: On/Off Power Switch / Always On Slave

Association Group Information

Group # / Max Description

• 1/5: Z-Wave Plus Lifeline. When the load state of Dual Nano Switch (turn on/off the load) is changed, the Hail CC and Basic Report (configured by parameter 80) can be sent to the associated nodes in this group.
• 2/5: Forward the Basic Set, Switch All, Scene Activation Set to associated nodes in Group 2 when the Dual Nano Switch receives the Basic Set, Switch All, Scene Activation Set commands from main controller. (E.g. Send/forward Basic Set to control the other nodes in association Group 2)
• 3/5: Send Basic Set (configured by parameter 0x51) to the associated nodes in Group 3 when the external switch S1 is operated. Note: The Switch Mode of external switch S1 should be identified successfully, which means that the value of Configuration parameter 0x78 should be non-zero, then the Basic Set can be sent to the associated nodes in Group 3 via triggering the S1 switch.
• 4/5: Send Basic Set (configured by parameter 0x52) to the associated nodes in Group 4 when the external switch S2 is operated. Note: The Switch Mode of external switch S2 should be identified successfully, which means that the value of Configuration parameter 0x79 should be non-zero, then the Basic Set can be sent to the associated nodes in Group 3 via triggering the S2 switch.

Supported Command Classes (20):

• Association Group Info
• Basic
• Configuration
• Firmware Update Meta-Data V2
• Meter V3
• Multi-Channel V4
• Powerlevel
• Scene Actuator Conf
• Switch All
• Version V2
• Association V2
• Clock
• Device Reset Locally
• Manufacturer Specific V2
• Multi-Channel Association V3
• Notification V4
• Scene Activation
• Security S0
• Switch Binary
• Z-Wave Plus Info V2

Controlled Command Classes (2):

• Basic
• Hail