HAMRON 011674 LED Strip Kit
This document provides operating instructions and specifications for the HAMRON 011674 LED Strip Kit.
Safety Instructions
Save these instructions for future reference.
WARNING!
- Do not use the product if it can in any way put the road safety of the vehicle at risk.
- Do not point the light at the driver or out from the vehicle. The buyer is responsible for installing and using the product as it is intended to be used and in accordance with the rules and regulations, and laws, concerning vehicle lights.
- The manufacturer cannot accept liability for any damage resulting from illegal or unintended use.
Symbols
- [Read instructions symbol] Read the instructions.
- [CE mark] Approved in accordance with the relevant directives.
- [WEEE symbol] Recycle discarded product in accordance with local regulations.
- [Scissors on strip symbol] Can be cut.
- [Roll of tape symbol] Self-adhesive.
- [Battery symbol] For 12 V.
- [Rain cloud symbol] Water-resistant.
Technical Data
| Specification | Value |
|---|---|
| Output | 18x0.2 W |
| Cable length | 100 cm |
| Voltage | 12 V |
| LED strips length | 30 cm |
Description
The kit includes the following components:
- Plug (12V car adapter)
- LED strips (30 cm)
- Connector
- Power switch
- Colour selector
- Sequence selector
FIG. 1: The kit includes a 12V car adapter plug, a wired control unit, two 30 cm LED strips, and connectors. The control unit features a power button, a color selection wheel (RGB), and a mode/sequence selection button.
Specifications
- 2 LED strips, 30 cm each
- Bright RGB LEDs
- Line-mounted control unit with 15 colour options
- 6 sequences in each colour option
- Can be cut to required length
- Self-adhesive – 3M foam rubber tape on back
- Simple mounting – pull off the protective film and press in place
- For 12 VDC
- Ideal for indoor installation
Use
Follow these steps for installation:
- Choose a suitable place to mount and cut the LED strip if necessary to the required length.
- Remove the protective film and fasten the LED strip in the required place.
- Plug the plug into the 12 V socket in the car.
Notes
- FIG. 2: The LED strip only works when the plug connectors are connected with the arrows opposite each other.
- FIG. 3: The LED strip can only be cut to the required length at the markings.
