Product Names
- LIGHT BAR LED
- LJUSRAMP LED
- LYSRAMPE LED
- TABLICA OŚWIETLENIOWA LED
- LED-LEUCHTSCHIENE
- LED-VALORAMPPI
- RAMPE D'ÉCLAIRAGE LED
- LED-LICHTBALK
Safety Instructions
- Read these instructions carefully before installation and save them for future reference.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
Symbols
- ? Read the instructions.
- CE Approved in accordance with the relevant directives/regulations.
- ♻️ Recycle discarded product in accordance with local regulations.
Technical Data
| Specification | Value |
|---|---|
| Rated Voltage | 9-36 VDC |
| Power | 140 W |
| Luminous Flux | 12500 Im |
| Colour Temperature | 6000 K |
| Beam, diffusion angle | 30° |
| Range (1 lux) | 442 m |
| Range (0.25 lux) | 883 m |
| Protection rating | IP68 |
| Cord length | 50 cm |
| E-approved | Yes |
| ETM* (Electronic thermal management) | Yes |
| Size | 728 x 40 x 58 mm |
| Weight | 2.1 kg |
* Electronic thermal management
Description
The product includes a mounting kit and a DT connector.
- 1. Bottom fastener
- 2. Side fastener
Diagrams:
Figure 1: A diagram showing the LED light bar mounted to a surface using brackets. Two magnified views illustrate the mounting hardware, including screws, washers, and nuts, for both bottom and side mounting options.
Figure 2: An image displaying the included accessories: a mounting kit with various brackets, screws, washers, nuts, and a DT connector with a short cable.
Installation
The product can be mounted with side or bottom fasteners.
- Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
- Put the screws in the holes, put on the lock washers and tighten the nuts.
Cable Colour Coding
- Red wire = positive (+)
- Black wire = earth (-)
Warnings
- The product must only be used within its rated voltage range, 12 to 24 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
Environmental Care
Recycle discarded product in accordance with local regulations.
The product should be recycled according to applicable regulations.
