Hamron LED Light Bar
Item no. 016039
Product Description
The Hamron LED Light Bar is a slim auxiliary lighting solution designed to make driving safer and less tiring. It offers a discrete and stylish appearance. The light bar is equipped with 27 x 5W LED light sources, providing 12200 theoretical lumens and 10370 actual lumens. The beam pattern is a "Combo beam," which means it emits a strong spot beam far ahead on the road, while diffuse side reflectors create a wide and uniform beam illuminating the road edges.
The LED light sources feature Electronic Thermal Management (ETM) to maintain diode intensity and prevent discoloration if the heat becomes excessive. It is designed for fixed installation and mounts using the supplied bottom or side fasteners made of stainless steel. Mounting accessories and a DT connector are included.
Beam Characteristics
The light bar features a "Combo beam" pattern, characterized by:
- Diffusion Angle: Provides a wide spread of light.
- Distance: The beam reaches 491 meters at 1 lux and 982 meters at 0.25 lux.
Light Pattern Diagram Description
The light pattern diagram illustrates the beam's distribution. It shows contours representing lux levels across distance and angle. The primary beam is focused forward, with a peak intensity indicated within the central area. The diagram shows the range capabilities: 1 lux at 491 meters and 0.25 lux at 982 meters.
Electronic Thermal Management (ETM)
ETM technology ensures that the intensity of the LED diodes is maintained and prevents discoloration by managing heat levels. This system helps to preserve the light output and quality over time.
Technical Data
| Specification | Value |
|---|---|
| Rated voltage | 9-36 VDC |
| Light source | 27 x 5W LED |
| Power | 135 W |
| Luminous flux | 12200 lm |
| Colour temperature | 6000 K |
| Range (1 lux) | 491 m |
| Range (0.25 lux) | 982 m |
| Protection rating | IP68 |
| Cord length | 50 cm |
| E-approved | Yes |
| ETM | Yes |
| Dimensions | W763 x H40.5 x D52.5 mm |
| Weight | 2 kg |
Safety Instructions
- Read these instructions carefully before installation and save them for future reference.
- Always comply with applicable laws and regulations for the installation and use of auxiliary headlights.
- Warning: The product must only be used within its rated voltage range (9-36 VDC).
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Ensure free airflow through the cooling fins and keep them clean.
Installation
- Disconnect the negative/chassis earth cable from the battery before connecting the product to avoid damage from short-circuiting during installation.
- Follow existing cable routing as much as possible when installing new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape, or equivalent. Cable grommets through the firewall should be at a safe distance from moving parts.
- Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
- The product can be mounted with side (1) or bottom (2) fasteners. Insert screws through the holes, add lock washers, and tighten the nuts.
Component Description (Figure 1)
The included mounting hardware consists of stainless steel brackets (side and bottom), screws, nuts, washers, an Allen key, and a DT connector with associated wiring.
Cable Colour Coding
The DT connector's red wire is (+) and the black wire is (-).
Symbols
- [Book Symbol]: Read the instructions.
- CE: Approved in accordance with relevant directives.
- [Recycling Symbol]: Recycle discarded product in accordance with local regulations.
Environmental Responsibility
Discarded products must be recycled according to applicable regulations.
For the latest version of the operating instructions, visit www.jula.com.
