OPTONICA

Mounting Options

The luminaire can be installed using two methods:

• Surface Mounting: The fixture is attached directly to the mounting surface.
• Suspension Mounting: The fixture is hung from the mounting surface using chains or ropes.

[Illustration showing two mounting methods: Surface Mounting and Suspension Mounting.]

Step 1: Prepare Mounting Surface

For Surface Mounting:

Mark the desired position and drill two holes. Insert screws, ensuring the distance between holes is no less than 50mm and less than the bracket length. The diagram shows two mounting brackets being secured to a surface with screws (ST4.2x30) ? and a screwdriver ?. The distance between the brackets is indicated by 'LF'.

[Illustration depicting surface mounting preparation: drilling holes, inserting screws, and attaching mounting brackets to a surface using installation screws ST4.2x30.]

For Suspension Mounting:

The diagram shows two mounting brackets suspended from the ceiling using chains ⛓️, with the distance between them indicated by 'LF'.

[Illustration depicting suspension mounting preparation: chains attached to mounting brackets.]

Step 2: Attach Luminaire Body

Press the lamp body firmly into the mounting buckle. Slide the lamp body along the mounting buckle to the desired position as needed.

[Illustration showing the luminaire body being pushed upwards onto the mounted brackets, with an arrow ⬆️ indicating 'PUSH' to secure the fixture.]

Step 3: Connect Wiring

Connect the wiring. Use insulating tape and waterproof tape for insulation and waterproofing. Turn the power ON and test.

Electrical Connection Details:

The connection wire diameter shall apply for 2G 1.0mm² - 2G 2.0mm². The diagram shows terminals labeled 'L' (Live) and 'N' (Neutral) ⚡ and a wire diameter range of Ø7-Ø10mm ?.

[Illustration of electrical connection terminals (L, N) and wire diameter specification (Ø7-Ø10mm) for 2G 1.0mm² - 2G 2.0mm² wires, including a cable gland.]