OPTONICA Outdoor LED STREET light

Diagram

The diagram illustrates the components of the LED Street Light. Key features include:

• A mounting bracket allowing 180 Degree Rotation.
• Bolts for securing the fixture.
• The main body constructed from ADC#12 Aluminum Alloy.
• A PC Lens for light diffusion.
• A 180 Degree Rotation Lever for adjustment.
• The power cable is specified as H05RN-3G0.75mm².

Important Safety Information

• Do not wire this lantern into the lighting circuit; use a switched fuse spur.
• Before installation and servicing, disconnect the electrical supply at the mains.
• Carefully observe all instructions or warnings that are labelled on, or supplied with, your product.
• This product is suitable for outdoor use. If in any doubt, consult a qualified electrician.

Fixing Instructions

• Do not wire this lantern into the lighting circuit - use a switched fuse spur.
• This fitting must be earthed. Contact a qualified electrician to install a suitable earth facility.
• Ensure the electricity is turned off at the mains before installing or maintaining any electrical fitting.
• Please note: For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mounting point for this product, before proceeding with the installation.

IMPORTANT WARNING

Please read the instructions carefully before installation and preserve it well. Recommend the lamp must be installed and assembled by a qualified electrician. Before installation, please cut off the main power. Turn off the circuit. Do not turn the lamp on before the end of installation. Please use proper wire for connection. The length of output leads should be typically 0.5m-2m in order to keep radio interference minimum.

Installation

The installation process involves several steps:

1. Figure 1: Shows the fixture and mounting bracket. The switch is indicated as OFF ?.
2. Figure 2: Illustrates mounting the fixture on the wall. This involves drilling holes, inserting wall plugs, and securing the bracket.
3. Figure 3: Depicts attaching the bracket to the wall. A warning symbol ⚠️ indicates "Danger of burns! Hot surface".
4. Figure 4: Shows the electrical connections: Brown wire, Yellow/Green wire (GND ?), and Blue wire (N). It also indicates re-attaching the luminaire using a suitable IP-rated box ?️.
5. Figure 5: Demonstrates adjusting the fixture to a 180-degree angle.
6. Figure 6: Shows the fixture in the ON position.

Note: This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive ♻️)

Importer Information

IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;