Included Parts
- (1) Exhaust Fascia, Black
- (1) Backer Plate, Raw
- (2) M4 Screw
- (2) M4 Washer
- (2) M4 Nyloc Nut
Required Tools
- 7, 10, 18mm Socket
- T-30 Socket
- 18mm Wrench
Installation Instructions
Step 1: Install the Backer Plate
Install the backer plate to the rear fascia using supplied M4 hardware. Place washers under the head of the screw. Do not over-tighten.
[Description of Figure 1: A hand is shown attaching the black backer plate to the rear fascia of a vehicle using an M4 screw and washer.]
Step 2: Remove Sway Bar Plastic Trim
With a T-30 socket, remove the sway bar plastic trim.
[Description of Figure 2: The underside rear of a vehicle is shown. Red circles highlight two T-30 bolts securing the plastic trim around the sway bar.]
Step 3: Remove Sway Bar Mounts
Remove (4) 18mm bolts and nuts holding the sway bar to the rear frame.
[Description of Figure 3: The underside rear of a vehicle is shown. Red circles highlight four 18mm bolts and nuts connecting the sway bar to the frame.]
Step 4: Remove Plastic Retaining Screws
Remove (2) 10mm screws located above the exhaust, which hold the plastic to the frame.
[Description of Figure 4: The underside rear of a vehicle is shown, focusing on the exhaust area. Red circles highlight two 10mm screws above the exhaust pipes that secure plastic components to the frame.]
Step 5: Install Exhaust Fascia
Install the fascia around the exhaust tips. Begin by aligning the top tabs behind the plastic trim and in front of the frame. Reinstall the original equipment manufacturer (OEM) hardware.
[Description of Figure 5: The rear of the vehicle is shown with the new fascia being positioned around the exhaust tips. A red box highlights the area where top tabs of the fascia align behind the plastic trim and in front of the frame.]
Step 6: Reinstall Components and Secure Fascia
Reinstall the sway bar mounts and plastic guard. Reuse the OEM hardware on the bottom to fasten the lower portion of the fascia.
[Description of Figure 6: The rear of the vehicle with the fascia installed is shown. Red circles indicate the lower portion of the fascia being secured with hardware.]
Product Information and Disclaimer
Thank you for choosing Evolution Powersports products. If you require further assistance, please contact Tech Support at (715) 247-3862.
Note: This product is exempt from emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law (e.g., vehicle code §§ 27156 and 38391). This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt, and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law. For questions, call Evolution Powersports at (715) 247-3862.
