IQ4 NS QUICK GUIDE

1 WALL MOUNT

1. With a small [Phillips screwdriver], undo the locking screw from the back of the panel and remove the SmartMount backplate.

2. Mount the backplate to the wall using flat head screws and appropriate wall anchors if needed, ensuring it is level.

   If using a model with a legacy security radio, drill a 1/4" hole in the wall in the provided hole on the right side of the backplate and feed the white RF antenna into the wall.

   A screw is required in the breakaway wall tamper for UL 2610 and EN Grade 2 installations.

3. Latch the top of the IQ4 NS onto the SmartMount backplate.

   Swing the panel down towards the backplate and press firmly against the wall.

4. With a small [Phillips screwdriver], screw in the locking screw from the bottom of the panel to secure it to the wall.

Power Connection and Power Up

Connect the power supply to the barrel jack on the back of the panel.

[Warning] Use 7vDC Power Supply ONLY.

Press and hold the [Power Button] on the right side of the panel for 3 seconds to power up.

Mobile App Integration

Options available: CREATE ACCOUNT, TRY THE MOBILE TECH APP.

5 SETUP WIZARD

From your smart device, download "IQ Installer" from the [App Store] or [Google Play] stores to connect to IQ4 NS over Wi-Fi to complete local system setup. To connect, complete the following steps:

1. Open the "IQ Installer Interface", tap Start on the phone screen to begin. Tap Scan QR Code, then position your phone and scan the QR label on the back of the panel or the side of the box. Tap Continue.

2. Press the [Power Button] twice within 3 seconds.

3. The Status LED will turn solid Blue. Tap Next on the screen.

4. Enter the default Installer (1111) or Dealer (2222) code to connect.

5. When prompted, change the default code to a new installer code.

6. Select Dashboard, then tap Launch Wizard.