Installation Manual

Step 1: Wire Bundle Placement

Decide whether the wire bundle needs to be towards the driver side or passenger side by testing when signals lights work properly.

Step 2: Peel Adhesive

After cleaning and drying the mounting surface, peel off the adhesive tape at the back.

[Image: Adhesive tape being peeled from a backing.]

Step 3: Stick Light Bar

According to the mounting direction of the wire bundle, stick the light bar to the recessed area between the bottom of the tailgate and the bumper shelf.

[Image: The light bar being adhered to the recessed area of a truck tailgate.]

Step 4: Electrical Hook-up

Plug and play the standard flat 4-pin connectors. Connect the reverse wire to a 12V DC positive power source.

[Image: Electrical connectors, showing a 4-pin flat connector with wires.]

Step 5: Additional Hardware

You can also add on an additional mount and screws provided to secure the light bar.

[Image: Additional mounting hardware, including plastic clips and screws.]