Puckipuppy Boxer Installation Manual
Model: Boxer
Brand: Puckipuppy
Introduction
Welcome to the installation manual for your new Puckipuppy Boxer. This guide provides step-by-step instructions to ensure a safe and correct setup of your product. Please read all instructions carefully before beginning.
Safety Precautions ⚠️
Before starting installation, please observe the following safety guidelines:
- Ensure the installation area is clear and well-lit.
- Keep children and pets away from the installation area.
- Use appropriate tools for assembly.
- If any part is damaged or missing, do not proceed with installation. Contact Puckipuppy support.
- Electrical connections should only be made by qualified personnel if applicable.
Package Contents
Verify that all components listed below are present in your package:
| Item | Description | Quantity |
|---|---|---|
| A | Main Unit | 1 |
| B | Mounting Bracket | 1 |
| C | Power Adapter | 1 |
| D | Screws (M4x10mm) | 4 |
| E | User Manual (This Document) | 1 |
Diagram Description: A visual representation of all package contents, labeled A through E, is typically shown here.
Installation Steps ⚙️
Follow these steps to install your Puckipuppy Boxer:
Step 1: Prepare the Mounting Location
Choose a stable, flat surface for mounting. Ensure there is adequate space around the unit for ventilation and access.
Step 2: Attach the Mounting Bracket
Using the provided screws (D), secure the Mounting Bracket (B) to the chosen surface. Refer to Diagram 2 for correct orientation.
Diagram Description: Diagram 2 illustrates the Mounting Bracket (B) being attached to a wall using Screws (D), showing the correct angle and placement.
Step 3: Mount the Main Unit
Carefully slide the Main Unit (A) onto the attached Mounting Bracket (B) until it clicks into place. Ensure it is securely fastened. Refer to Diagram 3.
Diagram Description: Diagram 3 shows the Main Unit (A) being slid onto the Mounting Bracket (B) with an arrow indicating the direction of attachment.
Step 4: Connect the Power Adapter
Plug the Power Adapter (C) into the power port on the Main Unit (A) and then into a suitable electrical outlet. A power indicator light should illuminate. ?
Step 5: Final Checks ✔️
Ensure all connections are secure and the unit is stable. The installation is now complete.
Basic Operation
Once installed, refer to the separate Basic Operation guide for instructions on using your Puckipuppy Boxer.
Troubleshooting ❓
If you encounter issues, consult the troubleshooting section in the full user manual or visit the Puckipuppy Help Center.
- No Power: Check power adapter connection and outlet.
- Unit Unstable: Ensure mounting bracket is securely fastened.
