Olight Baton 3 Premium Edition User Manual

In the Box

• Baton 3 (with battery)
• Baton 3 Wireless Charger
• USB Charging Cable
• Microfiber Cleaning Cloth

Specifications (Baton 3)

Performance

Note: All specifications are test results based on ANSI/NEMA FL1-2009 Standard. Tests are performed using the battery included in the flashlight.

Physical Characteristics

Baton 3 Wireless Charger Specifications

Product Overview

Baton 3

The Baton 3 features a side switch for operation, an external indicator light, a Type-C charging port, and an internal indicator.

Baton 3 Wireless Charger

The Wireless Charger includes an external indicator and a Type-C charging port.

Before Use the Wireless Charger

Open the lid of the wireless charger and remove the insulating film located between the charger and the flashlight.

Battery Installation

Before first use, unscrew the body and remove the insulating film. When replacing the battery, ensure the positive end of the new battery faces the flashlight head.

Available Batteries

• 1 x customized 550mAh 3.7V IMR16340 rechargeable battery. This battery is not compatible with any other batteries.

Battery Level Indicator (Baton 3)

• >60%: Green Indicator
• 20~60%: Orange Indicator
• 5~10%: Red Indicator
• <5%: Indicator Blinks Red

Note: If using moonlight mode, the battery indicator will only display when the battery level is below 5%.

Battery Level Indicator (Baton 3 Wireless Charger)

• >60%: Green Indicator
• 20~60%: Orange Indicator
• 10~20%: Red Indicator
• <10%: Indicator Blinks Red

Charging

Before first use, please fully charge the product.

Indicator Status: RED = Charging, GREEN = Charging Completed

Notice

• When the flashlight is turned off, the current mode will be memorized. The memorizable modes are: moonlight, low, medium, and high. After the light is turned off, the high mode will be memorized for 10 minutes before reverting to medium mode. If the light is turned off on turbo mode, the high mode will be memorized instead and will also revert to medium mode after 10 minutes (turbo mode cannot be memorized).
• Turbo mode will stay on for 1 minute and then step down to high mode within half a minute.
• Moonlight and turbo modes are not part of the normal brightness level cycle (low, medium, and high). Under moonlight and turbo modes, press and hold the switch to enter the normal brightness level cycle.
• When the product is used in a low-temperature environment, please try and keep it warm. If the temperature is too cold, it may not reach the highest output.
• Do not short-circuit the copper pole in the center of the tailcap with the flashlight’s metal housing. This can result in an electric discharge and may lead to complete battery drain if left in this state for too long.
• If charging the wireless charger with a flashlight inserted, the power source will charge the flashlight first if its capacity is below 5V 1A. In this case, the external indicator will show the charger’s remaining power, not the charging status.
• When the charger’s power runs low while charging a flashlight, the internal indicator will flash red, similar to the external indicator.
• The smart deactivation function is not compatible with the S1R II.
• The internal indicator will blink red if the wireless charger cannot charge the flashlight inside properly. This may occur if the flashlight’s battery housing is not screwed on tightly or if the charger's power is extremely low.

Safety Information

DANGER

• DO NOT separate the battery from the flashlight. The rechargeable IMR battery included has a strong discharge current. Short-circuiting can cause it to become hot, burn, or lead to unpredictable disasters.
• DO NOT cover the light head when the flashlight is on, or place the flashlight head on the ground. The radiation energy can damage the flashlight or cause burning to other materials.
• DO NOT shine the light directly into human eyes. This may cause temporary blindness or permanent eye damage.
• DO NOT remove or replace the built-in battery of the charger.
• DO NOT put the charger into fire or heat it.

WARNING

• Keep out of reach of children.
• When the flashlight is operating on high mode, the surface temperature can reach 50°C. Please switch off the flashlight temporarily or turn it to low mode.
• Please use turbo mode with caution. Turbo mode greatly reduces runtime and leads to high temperature on the flashlight surface.
• DO NOT use turbo mode continuously when the environmental temperature is high, as the flashlight body may become too hot to hold.
• If the product is left unused or is being carried and transported, please lock the button to prevent accidental activation.
• Please keep the front lens clean. Due to radiation energy, foreign matter on the lens may heat up and cause damage.
• The battery can only be stored inside the product and charged with the included specified charger.
• Store the battery with care. After removing the battery from the product, store it in a dedicated box in a cool and dry place.
• DO NOT short-circuit the charger’s magnetic charging port with any conductors.
• DO NOT forcefully press the elastic contact inside the charger to avoid damage.

Disclaimer

• DO NOT put a turned-on S1R II into the charger and close its lid, as the charger may be damaged by overheating.
• Please keep the magnetic charging port of the charger and the tailcap of the flashlight clean. Otherwise, it may fail to charge the flashlight or to deactivate the powered-on Baton 3.

Warranty

• Within 30 days of purchase: Contact the original seller for repair or replacement.
• Within 5 years of purchase: Contact Olight for repair or replacement.
• Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
• Baton 3 Wireless Charger: Two Years warranty.
• For fragile or low-value fittings (like lanyard and clip) not covered above, contact post-sale within 30 days of purchase if there are quality drawbacks or damage under normal use. For issues after 30 days or under abnormal use, conditional quality assurance will be offered.

Customer Support & Manufacturer Information

USA Customer Support: cs@olightstore.com

Global Customer Support: Customer-service@olightworld.com

Visit www.olightworld.com to see the complete product line of portable illumination tools.

Manufacturer: Dongguan Olight E-Commerce Technology Co., Ltd

Address: 4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China.

Made in China.

Document Version: C. 03, 02, 2021 | Model/Version ID: 3.0331.6010.9008

Contents

(Note: The following lists the sections and page numbers from the original document. It is not an interactive table of contents.)

• Page 01: EN English, CHS 简体中文
• Page 02: FI Finnish
• Page 03: NO Norwegian
• Page 04: SV Swedish
• Page 05: NED Nederland
• Page 06: PL Polska
• Page 07: DE Deutsch
• Page 09: HU Magyarország
• Page 10: RU Русский
• Page 11: ES Español
• Page 12: RO Românesc
• Page 13: UA Ukrainian
• Page 15: JP 日本語
• Page 16: KR 한국
• Page 17: TH ไทย
• Page 18: FR Français
• Page 19: BG български, IT Italia
• Page 21: IT Italia
• Page 22: SK Slovenskýjazyk