Cersanit Carina New Clean On Toilet: Installation and Operation Manual

Product Information

This document provides instructions for the installation and operation of the Cersanit Carina New Clean On toilet.

Brand: Cersanit

Model: Carina New Clean On

Model Number: S-KO-CAR011-3/5-COn-S-DL-w

Website: tm.by

Installation Instructions

Follow these steps for proper installation:

1. Step 1: Assemble the flushing mechanism. (Refer to Diagram 1A and 1B)
   • Insert the fill valve into the cistern.
   • Insert the flush valve into the cistern.
   • Connect the flush button mechanism.
2. Step 2: Prepare the cistern. (Refer to Diagram 2)
   • Attach the cistern to the toilet bowl using the provided bolts and seals. Ensure a watertight connection.
3. Step 3: Connect the water supply. (Refer to Diagram 3)
   • Connect the flexible water supply hose to the fill valve inlet.
   • Ensure the connection is secure.
4. Step 4: Mount the cistern to the bowl. (Refer to Diagram 4)
   • Place the cistern onto the toilet bowl, aligning the bolt holes.
   • Secure the cistern with the provided bolts.
5. Step 5: Attach the cistern lid. (Refer to Diagram 5)
   • Place the cistern lid onto the top of the cistern.
6. Step 6: Connect the cistern to the bowl. (Refer to Diagram 6)
   • a. Attach the flush pipe to the cistern outlet.
   • b. Attach the flush pipe to the bowl inlet.
   • c. Secure the connection with the provided seal and nut.
7. Step 7: Install the toilet seat. (Refer to Diagram 7)
   • Insert the seat hinges into the designated holes on the bowl.
   • Secure the hinges with the provided screws.
   • Attach the toilet seat to the hinges.
8. Step 8: Final connections and checks. (Refer to Diagram 8)
   • Ensure the water supply is connected and the shut-off valve is open.
   • Check for leaks around all connections.
   • Allow approximately 24 hours for the sealant to cure if used.
9. Step 9: Wall mounting (if applicable). (Refer to Diagrams 9.1 and 9.2)
   • Mark the desired position for the toilet on the wall.
   • Drill holes for the mounting brackets using a Ø10 drill bit.
   • Insert wall plugs and secure the brackets.
   • Mount the toilet to the wall brackets.
   • Ensure the toilet is level and stable.
10. Step 10: Water supply connection to wall. (Refer to Diagram 10)
    • Connect the water supply hose to the wall's water outlet.
    • Ensure a secure and watertight connection.
11. Step 11: Final checks. (Refer to Diagram 11)
    • Flush the toilet to test the flushing mechanism.
    • Check all connections for leaks.
    • Ensure the toilet seat is properly attached.

Operation and Maintenance

Flushing: Press the flush button to operate the flushing mechanism.

Water Supply: The toilet requires a continuous water supply. Ensure the shut-off valve is open during normal operation.

Cleaning: Clean the toilet regularly with mild soap and water. Avoid abrasive cleaners that may damage the surface.

Maintenance: Periodically check all connections for leaks and ensure the flushing mechanism is functioning correctly.

Troubleshooting

Leaking: Check all seals and connections. Tighten any loose fittings. If the leak persists, replace the faulty seal or component.

Weak Flush: Ensure the water supply is adequate and the cistern is filling correctly. Check for any blockages in the flush pipe.