FTPLPB-2010 FTPLPB-2011 HNFKS-V2 Assembly Instructions
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
Assembly Steps
- Assemble product on a flat, clean surface.
- Ensure that all screws are placed in correct positions prior to tightening.
- If a screw cannot be inserted, loosen it and try again. Once all screws are aligned and inserted, tighten them in a crisscross pattern.
- Do not fully tighten all screws until assembly is completed.
Parts List - Chairs
| Item No. | Reference Image Description | Qty. | Item No. | Reference Image Description | Qty. |
|---|---|---|---|---|---|
| A | Chair Leg (Front) | X6 | B | Chair Leg (Back) | X6 |
| C | Seat Frame Component | X6 | D | Seat Slat | X6 |
| E | Seat Cushion | X6 | J | Bolt (M6x15mm) | X36 |
| K | Bolt (M6x25mm) | X24 | M | Washer (14xΦ6.5x1mm) | X60 |
| N | Allen Wrench | X1 |
Step 1 (X6): Attach chair legs (A and B) to the seat frame components (C) using bolts (J) and washers (M). A detailed view shows a bolt (J) and washer (M) securing part C to part A. Ensure all 6 chairs are assembled this way.
Step 2 (X6): Attach seat slats (D) to the seat frame components (C) using bolts (J) and washers (M). A detailed view shows a bolt (J) and washer (M) securing part C to part D. Ensure all 6 chairs are assembled this way.
Step 3 (X6): Attach the chair back supports (part of the frame) to the seat assembly using bolts (K) and washers (M). A detailed view shows a bolt (K) and washer (M) securing the back support to the seat frame.
Step 4 (X6): Place the seat cushions (E) onto the assembled chair seats.
Installation Completed for chairs.
Parts List - Table
| Item No. | Reference Image Description | Qty. | Item No. | Reference Image Description | Qty. |
|---|---|---|---|---|---|
| F | Table Top Panel | X2 | G | Table Support Tray | X1 |
| H | Table Leg Support | X4 | I | Table Leg Connector | X2 |
| L | Bolt (M6x15mm) | X12 | O | Bolt (M6x25mm) | X12 |
| Q | Washer (14xΦ6.5x1mm) | X24 |
Step 1 (X1): Attach table leg supports (H) to the table top panels (F) using bolts (L) and washers (Q). A detailed view shows bolts (L) and washers (Q) securing part H to part F.
Step 2 (X1): Attach table leg connectors (I) to the table top panels (F) using bolts (L) and washers (Q). A detailed view shows bolts (L) and washers (Q) securing part I to part F.
Step 3 (X1): Attach the table support tray (G) to the table leg connectors (I) using bolts (O) and washers (Q). A detailed view shows bolts (O) and washers (Q) securing part G to part I.
Step 4 (X1): Invert the assembled table by rotating it 180 degrees to place it upright on its legs.
Installation Completed for table.
