SciCan BRAVO G4 Autoclave Quick Reference Guide

Basic Operation

1. Power unit ON.
2. Fill with demineralised/distilled water. NEVER USE TAP WATER ?
3. Load configurations.
4. Close unit.
5. Run cycle.
6. Open unit.
7. Unload instruments.
8. If required, drain manually.

Ventilation Requirements:

• Front & Side: 0.78 in / 20 mm clearance
• Back: 2.75 in / 70 mm clearance

Filling Options:

• Top Filling
• Front Filling

Draining Options:

• Manually (To Release)
• Automatic

Maintenance Schedule

Daily

Clean the door gasket and internal part of the door with a clean wet cloth. Check for wear and replace if required. Completely empty the waste tank before refilling the water reservoir.

Weekly

Clean the chamber and appropriate accessories with a wet cloth. If required, use a neutral detergent (without alkalines and bleaches). Carefully rinse with demineralized/distilled water and remove any residue. Inspect and clean chamber anti-dust filter. Replace if necessary. Ensure area around BRAVO G4 is dust free.

Monthly

Drain & clean the internal water reservoir as per the instructions outlined in the Operator's Manual. If applicable, clean the external water tank used for automatic filling.

Every 3 - 6 Months

Check the bacteriological filter and replace as required. Lubricate the door lock. Using a clean cloth, remove any residues and lubricate the inside of the bushing with a film of the silicone-based grease provided. Inspect and clean the chamber drain filter. Replace if required.

Every Year or 1,000 Cycles

Replace the door gasket.

Spare Parts and Accessories

Important!

Users of this device must be sure to select the most appropriate sterilization cycle according to the recommendations of the leading infection control authorities and local regulatory guidelines / recommendations.