POLVCDG X1 User Product Guide
Product Parameters
A line drawing of the POLVCDG X1 wireless earphones, showing the over-ear design with ear hooks.
Specifications
- Product model: X1
- Waterproof level: IPX6
- Wireless version: V5.4
- Transmission distance: ≤10m
- Music format support: MP3, WMA, WAV, APE, FLAC
- Battery: 200mAh
- Charging: About 2 hours
- Play time: 10H@65% volume
- Protocol: HFP A2DP AVRCP
Multiple Use Key
A diagram showing three buttons on an earphone component: a '-' button labeled 'Volume- key', a central button labeled 'Power switch', and a '+' button labeled 'Volume+ key'.
Key Functions
- Start: Long press the power button for 3 seconds. Blue light flashes for 2 seconds.
- Shutdown: Long press the power button for 3 seconds. Red light on for 1 second.
- Wireless /MP3 Mode Switch: Double click the power button.
- To answer a call: Press the power button once.
- End of call: Press the power button once.
- Volume increase: Press the volume+ key once.
- Volume Down: Press the volume- key once.
- Previous song: Long press the Volume- key for 1 second.
- Next song: Long press the Volume+ key for 1 second.
- Music play/Pause: Press the power button once.
Pairing and Pilot Lamp
A diagram showing a section of the earphone with a 'Pilot lamp' and a 'microphone' indicated.
Pairing State
After the device is powered on, enter pairing mode. When paired, the red and blue lights flash alternately.
Pairing Instructions
After entering the pairing state, open the Wireless on the device, search for the device name "POLVCDG X1", click the device "POLVCDG X1" to pair and connect successfully.
USB Data Transfer Mode
The blue indicator is blinking.
Indicator Lights
- When charging: The red light is on.
- When fully charged: The blue light is long on.
- Low battery warning: When the battery is low, the red light blinks and an alert tone plays every 3 minutes.
Dual Mode Switching
Applicable to 32g models.
A diagram showing buttons with '-' and '+' symbols, and a central 'Power switch' button.
Mode Operations
- Mode Switching: Double-click the power button to enter MP3 mode.
- Reminder: Boot automatically defaults to Wireless mode.
- MP3 (TF card) mode: Default sequential play, with memory function.
- Computer Side File Transfer (Song Download): Use the magnetic data cable to connect the headset to the computer. You can read the headset as a U disk. In the folder named "POLVCDG X16", you can perform file transfer.
Charging
- The headset uses a built-in rechargeable battery, which must be fully charged when using the headset for the first time. If the voice "drop" indicates low battery, charge the headset.
- Connect the charging cable to the magnetic charging port. It will be fully charged in about 2 hours. Charging status indicator: Blinking Breathing indicator, fully charged blue indicator.
Warnings
- Magnetic charging has corresponding positive and negative electrodes that allow normal charging by adsorption. Mutual exclusion can cause a short circuit.
- Rechargeable batteries must be disposed of properly for recycling. Do not put the battery in fire to avoid explosion.
Matters Needing Attention
- Do not soak the earphone in seawater/salt water. If exposed to rain, dry the charging magnetic part with a paper towel.
- If not used for a long time, charge it at least once a month.
- Do not disassemble any part of the product without permission. If defective, stop using immediately. Contact the seller for after-sales treatment.
- After exercise, wipe sweat from the headset, especially the charging magnetic suction port. Clean regularly to prevent corrosion and maintain service life.
- Keep away from fire, heat sources, freezing sources, and chemicals. Prohibit violent impact, disassembly, and extrusion.
- Use a charging head with output 5V/1A or less. Higher than 5V may cause the earphone to heat up, potentially damaging the battery and motherboard.
