Product Overview

This is a randomized antenna with a low visual impact, specially designed for locations where aesthetics are important. It is ideal for facades, historic buildings, protected areas, and balconies. The antenna is a 7-element directional Yagi type, manufactured with Microstrip technology.

The BOSS Tech system automatically controls the received signal level (whether very high or very low) to always provide an optimized output level. Its new design, featuring TForce technology, makes this intelligent device even more versatile.

The product is RED compliant.

Product Identification & Characteristics

Key Advantages

• High dynamic range: Allows reception of quality TV in a wide variety of critical situations, from zones with very weak signals to installations with high reception levels.
• Increased TDT coverage area.
• High gain.
• More stable reception: Withstands signal variations or drops ("fading") without affecting the TV installation.
• Supports installation for horizontal and vertical polarization.
• LTE Ready: Integrated filter against LTE signals present in the vicinity, due to the use of 4G/5G devices.
• Two operating modes:
  • In intelligent mode (powering the antenna), the BOSS provides automatic regulation to correct signal oscillations and maintain an optimized output level.
  • In passive mode, it allows signal pass-through (without power).
• Corrosion Protection:
  • Reinforced yoke support with fiberglass: does not oxidize, reduces antenna weight, and optimizes material performance in outdoor conditions.
  • Yoke protected with RPR, offering a robust fixing.
  • High-resistance casing for salinity, humidity, and other adverse climatic phenomena (IP 53).
• Reduced consumption in intelligent mode.
• Simple assembly. Kits with all necessary accessories for installation can be purchased.

Technology Deep Dive

TForce Technology

Televés surpasses the silicon era and takes a step into the new era of electronic component design, enabling integrated circuits that operate in the microwave frequency band. TForce is based on manufacturing with semiconductor compounds like Gallium Arsenide (GaAs), allowing integrated products to achieve hard-to-match functionalities.

Televés reinvented the antenna concept. Until now, an antenna was limited to being the receiver element in a TV installation where gain and directivity were the key characteristics. The introduction of an intelligent device like BOSS has endowed the antenna with the ability to receive very weak signals without the risk of being affected by very strong signals where fluctuations do not impact the final result: the "Dynamic Range" concept thus emerges as the most notable among the quality parameters.

The creation of a BOSS with TForce technology, based on the use of MMIC components, is an extraordinary reference in the optimization of Dynamic Range. This technology enabled the recovery of lost signals from distant satellites and increases the coverage range in TDT installations.

Fiberglass Reinforced: What Does Fiberglass Add to Our Products?

Reinforced fiberglass plastics offer greater durability, are anti-magnetic, fire-resistant, and provide excellent electrical insulation. The main advantages of using fiberglass in our antennas are:

• Immunity to corrosion.
• Reduced weight, making assembly simpler.
• Flexibility, improving performance in adverse climatic conditions.

NOVA Series

In this special series, the antennas are intended for installation in atypical situations.

General Features & Application Example

Known for its low visual impact, pleasant, and discreet design, ideal for installations where good aesthetics are important.

Intelligent antennas incorporating the BOSS system allow them to always offer the best possible output level for good reception quality.

Designed to optimize LTE band rejection through electronic filtering.

LTE Ready: Incorporate an integrated LTE/4G filter to eliminate interference from wireless telephony networks.

Constructed with high-resistance materials against salinity, humidity, and other adverse climatic elements, providing an IP 53 protection index.

Low electrical consumption and easy assembly. They can be purchased in complete kits with all necessary accessories for installation.

Manufactured in Europe, subjected to rigorous quality controls that ensure high reliability.

Diagrammatic Documentation

Installation Diagrams

The diagrams illustrate typical installation scenarios. Page 5 shows an antenna receiving 12-24 Vdc power and outputting MATV. One configuration connects to a 196-264V~ power supply and distributes MATV to two televisions. Another configuration uses a 12-24V battery to power the antenna, distributing MATV to one television.

Page 6 shows a single antenna setup with MATV output to a television. It also includes a UHF radiation pattern diagram, indicating signal strength (labeled P.E. and P.H., likely representing Polarização Elíptica and Polarização Horizontal respectively) at various angles.

Page 7 is titled "Diagrama de radiação" (Radiation Diagram) but contains no visual information.

Technical Specifications: Ref. 144022

*1 Gain varies automatically depending on the output level.