USER MANUAL FOR LED EMERGENCY LIGHT

PRESENTATION OF THE FUNCTION

This section details the functions and internal components of the LED Emergency Light.

Internal Components Diagram Description:

• 1. Lithium Battery: Features a 3.7V 2200mAh lithium battery with an approximate lifespan of 2 years. The battery can be replaced with one of the same type if its lifespan is insufficient.
• 2. Battery Socket Connector: The battery socket is factory-connected by default. It is recommended to disconnect it prior to installation.
• 3. Input Terminal: Connects to a power cord (85-265V) to activate the working state.
• 4. Mode Selector Plug: The unit is factory-set to a non-persistent (emergency) mode. For continuous operation, the one-pin plug can be replaced with a two-pin plug.
• 5. Outlet Hole: A reserved opening for routing the power cord before wiring and energizing.

A circuit board is also visible within the unit.

INSTALLATION PROCEDURE

1. Remove the retaining screw, open the protective mask, select the appropriate exit hole, and connect the input power line.
2. Securely fasten the lamp to its intended installation location.
3. Connect the battery socket connector.
4. Choose the desired operating mode according to your requirements, referencing the function description.

ATTENTION

• Ensure all screws are tightened securely to prevent the ingress of water and dust, thereby extending the product's service life.
• Do not alter the light source.
• Do not attempt to disassemble the unit.